2020-19906. Airworthiness Directives; Leonardo S.p.a. Helicopters  

  • Start Preamble Start Printed Page 55781

    AGENCY:

    Federal Aviation Administration (FAA), DOT.

    ACTION:

    Final rule.

    SUMMARY:

    The FAA is adopting a new airworthiness directive (AD) for Leonardo S.p.a. (Leonardo) Model AB139 and AW139 helicopters. This AD requires removing certain main gearbox (MGB) input modules from service. This AD was prompted by the discovery that a batch of duplex bearings, which are installed on the MGB input modules, are defective. The actions of this AD are intended to address an unsafe condition on these products.

    DATES:

    This AD is effective October 15, 2020.

    ADDRESSES:

    For service information identified in this final rule, contact Leonardo S.p.a. Helicopters, Emanuele Bufano, Head of Airworthiness, Viale G.Agusta 520, 21017 C.Costa di Samarate (Va) Italy; telephone +39-0331-225074; fax +39-0331-229046; or at https://www.leonardocompany.com/​en/​home. You may view this service information at the FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177. For information on the availability of this material at the FAA, call 817-222-5110.

    Examining the AD Docket

    You may examine the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No FAA-2020-0554; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD, and other information. The address for Docket Operations is U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Rao Edupuganti, Aviation Safety Engineer, Regulations and Policy Section, Rotorcraft Standards Branch, FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177; telephone 817-222-5110; email rao.edupuganti@faa.gov.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Discussion

    The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to Leonardo Model AB139 and AW139 helicopters with certain serial-numbered MGB input modules part number (P/N) 3K6320A00135 or P/N 3K6320A00136 installed. The NPRM published in the Federal Register on June 8, 2020 (85 FR 35018). The NPRM proposed to require removing the affected MGB input modules from service and prohibit installing the affected MGB input modules. The proposed requirements were intended to address defective duplex bearings on MGB input modules, which could result in damage including corrosion and cracking, which could result in excessive heat of the input module duplex ball bearing inner race and subsequent loss of engine power and loss of helicopter control.

    The NPRM was prompted by EASA AD No. 2016-0255R1, dated January 17, 2017 (EASA AD 2016-0255R1), issued by EASA, which is the Technical Agent for the Member States of the European Union, to correct an unsafe condition for Leonardo (formerly Finmeccanica S.p.A., AgustaWestland Philadelphia Corporation, Agusta Aerospace Corporation) Model AB139 and AW139 helicopters with certain serial-numbered MGB input modules P/N 3K6320A00135 or P/N 3K6320A00136 installed. EASA advises that the supplier of a batch of duplex bearings installed on MGB input modules reported that the bearings were defective, due to a quality control issue. This condition, if not detected or corrected, could lead to damage of the input module duplex ball bearing inner race, possibly resulting in loss of engine power and reduced control of the helicopter. Accordingly, EASA AD 2016-0255R1 requires removing the affected MGB input modules from service.

    Comments

    The FAA gave the public the opportunity to participate in developing this final rule. The FAA received one comment in support of the NPRM.

    FAA's Determination

    These helicopters have been approved by EASA and are approved for operation in the United States. Pursuant to the FAA's bilateral agreement with the European Union, EASA has notified the FAA about the unsafe condition described in its AD. The FAA is issuing this AD after evaluating all known relevant information and determining that an unsafe condition is likely to exist or develop on other helicopters of the same type designs.

    Differences Between This AD and the EASA AD

    The EASA AD requires returning affected parts and sending information to Leonardo; however, this AD does not.

    Related Service Information

    The FAA reviewed Leonardo Helicopters Bollettino Tecnico No. 139-303, dated September 20, 2016, which specifies replacing certain duplex bearings on MGB left-hand and right-hand input modules on Model AB139 and AW139 helicopters.

    Costs of Compliance

    The FAA estimates that this AD affects 71 helicopters of U.S. Registry. The FAA estimates that operators may incur the following costs in order to comply with this AD. Labor costs are estimated at $85 per work-hour.

    Replacing one input module takes about 60 work-hours and parts cost about $84,847 for an estimated cost of $89,947 per input module. Replacing two input modules takes about 100 work-hours and parts cost about $169,694 for an estimated cost of $178,194 per two input modules.Start Printed Page 55782

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

    The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    Regulatory Findings

    This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify that this AD:

    (1) Is not a “significant regulatory action” under Executive Order 12866,

    (2) Will not affect intrastate aviation in Alaska, and

    (3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    Adoption of the Amendment

    Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

    Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

    End Amendment Part

    2020-19-04 Leonardo S.p.a.: Amendment 39-21245; Docket No. FAA-2020-0554; Product Identifier 2016-SW-088-AD.

    (a) Applicability

    This AD applies to Leonardo S.p.a. Model AB139 and AW139 helicopters, certified in any category, with main gearbox (MGB) input module part number (P/N) 3K6320A00135 with serial number (S/N) KHI-200 or P/N 3K6320A00136 with an S/N listed in Table 1 to this paragraph installed.

    Start Printed Page 55783

    (b) Unsafe Condition

    This AD defines the unsafe condition as defective duplex bearings on MGB input modules, due to a quality control issue. This condition could result in damage including corrosion and cracking, which could result in excessive heat of the input module duplex ball bearing inner race and subsequent loss of engine power and loss of helicopter control.

    (c) Effective Date

    This AD becomes effective October 15, 2020.

    (d) Compliance

    You are responsible for performing each action required by this AD within the specified compliance time unless it has already been accomplished prior to that time.

    (e) Required Actions

    (1) If the P/N and S/N of both MGB input modules are listed in paragraph (a) of this AD, within 300 hours time-in-service (TIS), remove from service each MGB input module.

    (2) If the P/N and S/N of only one MGB input module are listed in paragraph (a) of this AD, within 1,200 hours TIS, remove from service that MGB input module.

    (3) After the effective date of this AD, do not install an MGB input module with a P/N and S/N listed in paragraph (a) of this AD on any helicopter.

    (f) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, Rotorcraft Standards Branch, FAA, may approve AMOCs for this AD. Send your proposal to: Rao Edupuganti, Aviation Safety Engineer, Regulations and Policy Section, Rotorcraft Standards Branch, FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177; telephone 817-222-5110; email 9-ASW-FTW-AMOC-Requests@faa.gov.

    (2) For operations conducted under a 14 CFR part 119 operating certificate or under 14 CFR part 91, subpart K, the FAA suggests that you notify your principal inspector, or lacking a principal inspector, the manager of the local flight standards district office or certificate holding district office before operating any aircraft complying with this AD through an AMOC.

    (g) Additional Information

    (1) Leonardo Helicopters Bollettino Tecnico No. 139-303, dated September 20, 2016, which is not incorporated by reference, contains additional information about the subject of this AD. For service information identified in this AD, contact Leonardo S.p.a. Helicopters, Emanuele Bufano, Head of Airworthiness, Viale G.Agusta 520, 21017 C.Costa di Samarate (Va) Italy; telephone +39-0331-225074; fax +39-0331-229046; or at https://www.leonardocompany.com/​en/​home. You may view a copy of the service information at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N-321, Fort Worth, TX 76177.

    (2) The subject of this AD is addressed in European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD No. 2016-0255R1, dated January 17, 2017. You may view the EASA AD on the internet at https://www.regulations.gov in Docket No. FAA-2020-0554.

    (h) Subject

    Joint Aircraft Service Component (JASC) Code: 6320, Rotor Drive-Gearbox.

    Start Signature

    Issued on September 3, 2020.

    Lance T. Gant,

    Director, Compliance & Airworthiness Division, Aircraft Certification Service.

    End Signature End Supplemental Information

    BILLING CODE 4910-13-P

    BILLING CODE 4910-13-C

    [FR Doc. 2020-19906 Filed 9-9-20; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Effective Date:
10/15/2020
Published:
09/10/2020
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final rule.
Document Number:
2020-19906
Dates:
This AD is effective October 15, 2020.
Pages:
55781-55783 (3 pages)
Docket Numbers:
Docket No. FAA-2020-0554, Product Identifier 2016-SW-088-AD, Amendment 39-21245, AD 2020-19-04
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
2020-19906.Pdf
Supporting Documents:
» Airworthiness Directives: Leonardo S.p.a. Helicopters
» Supporting AD Documents
» Airworthiness Directives: Leonardo S.p.a. Helicopters
CFR: (1)
14 CFR 39.13