[Federal Register Volume 64, Number 180 (Friday, September 17, 1999)]
[Rules and Regulations]
[Pages 50439-50440]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 99-24088]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 98-CE-119-AD; Amendment 39-11319; AD 99-19-32]
RIN 2120-AA64
Airworthiness Directives; Pilatus Aircraft Ltd. Models PC-12 and
PC-12/45 Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD) that
applies to certain Pilatus Aircraft Ltd. (Pilatus) Models PC-12 and PC-
12/45 airplanes. This AD requires inspecting all flap actuator internal
gear systems to assure that correct end-play and backlash measurements
exist, and accomplishing any corrective adjustments as necessary. This
AD is the result of mandatory continuing airworthiness information
(MCAI) issued by the airworthiness authority for Switzerland. The
actions specified by this AD are intended to prevent premature wear of
the internal gear system caused by excessive backlash in the flight
control flap actuators, which could eventually result in loss of
actuator output with possible reduced or loss of airplane control.
DATES: Effective November 8, 1999.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of November 8, 1999.
ADDRESSES: Service information that applies to this AD may be obtained
from Pilatus Aircraft Ltd., Customer Liaison Manager, CH-6371 Stans,
Switzerland; telephone: +41 41 619 63 19; facsimile: +41 41 610 33 51.
This information may also be examined at the Federal Aviation
Administration (FAA), Central Region, Office of the Regional Counsel,
Attention: Rules Docket No. 98-CE-119-AD, Room 1558, 601 E. 12th
Street, Kansas City, Missouri 64106; or at the Office of the Federal
Register, 800 North Capitol Street, NW, suite 700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Mr. Roman T. Gabrys, Aerospace
Engineer, FAA, Small Airplane Directorate, 1201 Walnut, suite 900,
Kansas City, Missouri 64106; telephone: (816) 426-6932; facsimile:
(816) 426-2169.
SUPPLEMENTARY INFORMATION:
Events Leading to the Issuance of This AD
A proposal to amend part 39 of the Federal Aviation Regulations (14
CFR part 39) to include an AD that would apply to certain Pilatus
Models PC-12 and PC-12/45 airplanes was published in the Federal
Register as a notice of proposed rulemaking (NPRM) on June 23, 1999 (64
FR 33445). The NPRM proposed to require inspecting all flap actuator
internal gear systems to assure that correct end-play and backlash
measurements exist, and accomplishing any corrective adjustments as
necessary.
The affected airplanes could incorporate one of the following
flight control flap actuators:
--Pilatus part number (P/N) 978.71.20.302--Actuator, Linear (951D100-
5);
--Pilatus P/N 978.71.20.303--Actuator, Linear (951D100-7); and
--Pilatus P/N 978.71.20.304--Actuator, Linear (951D100-9).
Accomplishment of the proposed inspection as specified in the NPRM
would be required in accordance with Pilatus Service Bulletin No. 27-
005, dated November 18, 1998. Accomplishment of the proposed
adjustments, if necessary, would be required in accordance with the
maintenance manual.
The NPRM was the result of mandatory continuing airworthiness
information (MCAI) issued by the airworthiness authority for
Switzerland.
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were received on the
proposed rule or the FAA's determination of the cost to the public.
The FAA's Determination
After careful review of all available information related to the
subject presented above, the FAA has determined that air safety and the
public interest require the adoption of the rule as proposed except for
minor editorial corrections. The FAA has determined that these minor
corrections will not change the meaning of the AD and will not add any
additional burden upon the public than was already proposed.
Cost Impact
The FAA estimates that 69 airplanes in the U.S. registry will be
affected by this AD, that it will take approximately 6 workhours per
airplane to accomplish this action, and that the average labor rate is
approximately $60 an hour. The manufacturer will provide parts free-of-
charge to the owners/operators of the affected aircraft. Based on these
figures, the total cost impact of this AD on U.S. operators is
estimated to be $24,840, or $360 per airplane.
Regulatory Impact
The regulations adopted herein will not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this final
rule does not have sufficient federalism implications to warrant the
preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A copy of the final evaluation prepared for this
action is contained in the Rules Docket. A copy of it may be obtained
by contacting the Rules Docket at the location provided under the
caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation
[[Page 50440]]
Administration amends part 39 of the Federal Aviation Regulations (14
CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding a new airworthiness directive
(AD) to read as follows:
99-19-32 Pilatus Aircraft Ltd.: Amendment 39-11319; Docket No. 98-
CE-119-AD.
Applicability: Models PC-12 and PC-12/45 airplanes, manufacturer
serial numbers (MSN) 101 through MSN 236; certificated in any
category, that have one of the following flight control flap
actuators installed:
--Pilatus part number (P/N) 978.71.20.302--Actuator, Linear
(951D100-5);
--Pilatus P/N 978.71.20.303--Actuator, Linear (951D100-7); and
--Pilatus P/N 978.71.20.304--Actuator, Linear (951D100-9).
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (d) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated in the body of this AD, unless
already accomplished.
To prevent premature wear of the internal gear system caused by
excessive backlash in the flight control flap actuators, which could
eventually result in loss of actuator output with possible reduced
or loss of airplane control, accomplish the following:
(a) Within the next 50 hours time-in-service (TIS) after the
effective date of this AD, inspect all flap actuator internal gear
systems to assure that correct end-play and backlash measurements
exist, in accordance with the ACCOMPLISHMENT INSTRUCTIONS section of
Pilatus Service Bulletin No. 27-005, dated November 18, 1998. Prior
to further flight, perform any corrective adjustments, as necessary,
in accordance with the maintenance manual.
(b) As of the effective date of this AD, no person may install,
on any affected airplane, a flap actuator that has not been
inspected and adjusted (as necessary) as required by paragraph (a)
this AD.
Note 2: The FAA recommends that the most up-to-date Pilatus
reports and revisions pertaining to this subject be incorporated
into the Pilatus PC-12 Maintenance Manual. The most up-to-date
documents at the date of issuance of this AD are Temporary Revision
No. 27-04, dated November 18, 1998; and Temporary Revision No. 04-
04, dated June 16, 1999.
(c) Special flight permits may be issued in accordance with
Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR
21.197 and 21.199) to operate the airplane to a location where the
requirements of this AD can be accomplished.
(d) An alternative method of compliance or adjustment of the
compliance times that provides an equivalent level of safety may be
approved by the Manager, Small Airplane Directorate, 1201 Walnut,
suite 900, Kansas City, Missouri 64106. The request shall be
forwarded through an appropriate FAA Maintenance Inspector, who may
add comments and then send it to the Manager, Small Airplane
Directorate.
Note 3: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the Small Airplane Directorate.
(e) Questions or technical information related to Pilatus
Service Bulletin No. 27-005, dated November 18, 1998, should be
directed to Pilatus Aircraft Ltd., Customer Liaison Manager, CH-6371
Stans, Switzerland; telephone: +41 41 619 63 19; facsimile: +41 41
610 33 51. This service information may be examined at the FAA,
Central Region, Office of the Regional Counsel, Room 1558, 601 E.
12th Street, Kansas City, Missouri 64106.
(f) The inspections required by this AD shall be done in
accordance with Pilatus Service Bulletin No. 27-005, dated November
18, 1998. This incorporation by reference was approved by the
Director of the Federal Register in accordance with 5 U.S.C. 552(a)
and 1 CFR part 51. Copies may be obtained from Pilatus Aircraft
Ltd., Customer Liaison Manager, CH-6371 Stans, Switzerland. Copies
may be inspected at the FAA, Central Region, Office of the Regional
Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri, or at
the Office of the Federal Register, 800 North Capitol Street, NW,
suite 700, Washington, DC.
Note 4: The subject of this AD is addressed in Swiss AD HB 98-
460, dated November 23, 1998.
(g) This amendment becomes effective on November 8, 1999.
Issued in Kansas City, Missouri, on September 9, 1999.
Michael K. Dahl,
Acting Manager, Small Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 99-24088 Filed 9-16-99; 8:45 am]
BILLING CODE 4910-13-P
