96-24173. Michelin North America, Inc.; Grant of Application for Decision of Inconsequential Noncompliance  

  • [Federal Register Volume 61, Number 184 (Friday, September 20, 1996)]
    [Notices]
    [Pages 49522-49523]
    From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
    [FR Doc No: 96-24173]
    
    
    -----------------------------------------------------------------------
    
    DEPARTMENT OF TRANSPORTATION
    National Highway Traffic Safety Administration
    [Docket No. 96-068; Notice 2]
    
    
    Michelin North America, Inc.; Grant of Application for Decision 
    of Inconsequential Noncompliance
    
        This notice grants the application by Michelin North America, Inc. 
    (Michelin) of Greenville, South Carolina, to be exempted from the 
    notification and remedy requirements of 49 U.S.C. 30118, 30120 for a 
    noncompliance with 49 CFR 571.109, Federal Motor Vehicle Safety 
    Standard (FMVSS) No. 109, ``New Pneumatic Tires.'' The basis of the 
    application is that the noncompliance is inconsequential as it relates 
    to motor vehicle safety.
        Notice of receipt of the application was published on June 25, 
    1996, and an opportunity was afforded for comment (Vol. 61, No. 123 CFR 
    32896).
    
    Background
    
        Paragraph S4.3(a) of FMVSS No. 109 requires tires to be labeled 
    with one size designation, except that equivalent inch and metric size 
    designations may be used.
        Michelin's description of noncompliance follows:
        ``During the period of the 25th week through the 45th week of 1995, 
    the Ardmore, Oklahoma, plant of Uniroyal Goodrich Tire Manufacturing, a 
    division of Michelin North America, Inc., produced tires with two size 
    designations specified on one sidewall of the tire. Specifically, in 
    the upper sidewall of the tire, in letters 0.44 inches high, the tire 
    was correctly marked as a 205/70R15. The tire was incorrectly marked in 
    the lower sidewall area, in letters 0.25 inches high, as a 205/75R15. 
    This incorrect marking occurred on the side opposite the DOT tire 
    identification number. The correct marking also appears in two places 
    on the side that contains the DOT tire identification number. The 
    markings specified by 49 CFR 571.109 S4.3(a) call for only one size 
    designation. All performance requirements of FMVSS #109 are met or 
    exceeded for these tires.
        ``Approximately 4,708 205/70R15 BF Goodrich Touring T/A SR4 tires 
    were produced with the aforementioned information on one sidewall of 
    the tire. Of this total, as many as 730 were shipped to the replacement 
    market. The remaining tires have been isolated in [Michelin's] 
    warehouses and will be brought into full compliance with the marking 
    requirements of FMVSS No. 109 or scrapped.''
        Michelin supported its application for inconsequential 
    noncompliance with the following:
        ``1. All tires have a paper label, showing the correct size, 
    applied to the tire tread. Tires are generally `pulled from the rack' 
    based on the paper label. Thus information on the correct tire size for 
    the application would be available.
        ``2. The tire size is incorrect, in one of four places, only with 
    respect to the aspect ratio (or series), that is 75. Both the section 
    width designation of 205 and the rim diameter code of 15 are correct. 
    The correct maximum load and inflation pressure for the 205/70R15 is 
    molded on both sides of the tire.
        ``3. The tire size is correctly stamped on both sides in letters 
    0.44 inch high. Thus attention should be more readily drawn to the 
    correct tire size than to the incorrect size which is in much smaller 
    letters.
        ``4. When these tires are mounted on the vehicle, the `clean' side 
    (i.e. the side
    
    [[Page 49523]]
    
    without the bar code lines) is mounted out. Thus when mounting these 
    tires on a vehicle, the proper size designation is readily apparent in 
    two places on the sidewall.''
        Michelin's initial argument did not support its application that 
    the labeling noncompliance was inconsequential with respect to motor 
    vehicle safety. The agency's concern regarding the mislabeling was what 
    bearing the aspect ratio would have on the load-carrying capacity of 
    the tire. In this case, the load carrying capacity of the tire could be 
    miscalculated by as much as 88 pounds (6%) because of the wrong aspect 
    ratio being printed on the tire. Therefore, during the comment period, 
    NHTSA sought further information from the petitioner on what 
    consequences the alleged noncompliance would have on motor vehicle 
    safety.
        The petitioner responded with the following additional information:
         Tests conducted on the mislabeled tires at the higher 
    loads specified for a 205/75R15 tire exceeded all FMVSS No. 109 
    performance requirements.
         In the unlikely event that the tire would be fitted to a 
    vehicle as a replacement for a 205/75R15, the tire would be able to 
    carry the additional load and exceed all FMVSS No. 109 resistance to 
    bead unseating, strength, endurance, and high speed performance 
    requirements.
        A summary of the test results follows:
    
    ----------------------------------------------------------------------------------------------------------------
                                        Tire                                                                        
                   Test                 No.#          Result              Requirement               Comment         
    ----------------------------------------------------------------------------------------------------------------
    High Speed Performance...........       1  5.6 hours...........  5.0 hours...........  429 miles.               
                                            2  5.7 hours...........  5.0 hours...........  437 miles.               
    Tire Endurance...................       1  56 hours............  34 hours............  2800 miles.              
                                            2  56 hours............  34 hours............                           
    Tire Strength....................       1  5131 in-lbs.........  2600 in-lbs (min)...  Result=min of 5 test     
                                            2  4862 in-lbs.........  2600 in-lbs (min)...   values per tire.        
    Resistance to Bead Unseating.....       1  2830 lbs............  2500 lbs (min)......  Result=min of 5 test     
                                            2  2900 lbs............  2500 lbs (min)......   values per tire.        
    ----------------------------------------------------------------------------------------------------------------
    
        Michelin reported that all of the tires summarized in the above 
    chart were tested in accordance with the procedures defined in 49 CFR 
    Sec. 571.109. Loading of the tires was based upon a maximum tire load 
    of 1609 pounds for the 205/75R15 instead of the 1521 pound maximum load 
    of the 205/70R15.
    
    Comments
    
        No comments were received on the application.
    
    Discussion and Recommendation
    
        In response to NHTSA's request, Michelin submitted additional test 
    data in support of its inconsequentiality application. We believe these 
    data more adequately support the application for labeling noncompliance 
    since tests conducted on the mislabeled tires at the higher loads 
    specified for a 205/75R15 tire exceeded all FMVSS No. 109 performance 
    requirements.
        Therefore, additional information provided by the petitioner, the 
    petitioner's willingness to bring the remaining tires into full 
    compliance (3,978) with the marking requirements of FMVSS No. 109, or 
    scrap the remaining tires, satisfies our concern that motor vehicle 
    safety will not be compromised.
        Accordingly, for the reasons expressed above, the petitioner has 
    met its burden of persuasion that the noncompliance herein described is 
    inconsequential as it relates to motor vehicle safety, and the agency 
    grants Michelin's application for exemption from notification of the 
    noncompliance as required by 49 U.S.C. 30118 and from remedy as 
    required by 49 U.S.C. 30120.
    (49 U.S.C. 30118, 30120; delegation of authority at 49 CFR 501.8).
    
        Issued on: September 16, 1996.
    L. Robert Shelton,
    Acting Associate Administrator for Safety Performance Standards.
    [FR Doc. 96-24173 Filed 9-19-96; 8:45 am]
    BILLING CODE 4910-59-P
    
    
    

Document Information

Published:
09/20/1996
Department:
National Highway Traffic Safety Administration
Entry Type:
Notice
Document Number:
96-24173
Pages:
49522-49523 (2 pages)
Docket Numbers:
Docket No. 96-068, Notice 2
PDF File:
96-24173.pdf