2011-24111. Agency Information Collection Activities; Submission to OMB for Review and Approval; Comment Request; NESHAP for Friction Materials Manufacturing (Renewal)  

  • Start Preamble

    AGENCY:

    Environmental Protection Agency (EPA).

    ACTION:

    Notice.

    SUMMARY:

    In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), this document announces that an Information Collection Request (ICR) has been forwarded to the Office of Management and Budget (OMB) for review and approval. This is a request to renew an existing approved collection. The ICR which is abstracted below describes the nature of the collection and the estimated burden and cost.

    DATES:

    Additional comments may be submitted on or before October 20, 2011.

    ADDRESSES:

    Submit your comments, referencing docket ID number EPA-HQ-OECA-2011-0204, to (1) EPA online using http://www.regulations.gov (our preferred method), or by e-mail to docket.oeca@epa.gov, or by mail to: EPA Docket Center (EPA/DC), Environmental Protection Agency, Enforcement and Compliance Docket and Information Center, mail code 28221T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW., Washington, DC 20503.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Learia Williams, Monitoring, Assistance, and Media Programs Division, Office of Compliance, Mail Code 2223A, Environmental Protection Agency, 1200 Pennsylvania Avenue, NW., Washington, DC 20460; telephone number: (202) 564-4113; fax number: (202) 564-0050; e-mail address: williams.learia@epa.gov.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On May 9, 2011 (76 FR 26900), EPA sought comments on this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional comments on this ICR should be submitted to EPA and OMB within 30 days of this notice.

    EPA has established a public docket for this ICR under docket ID number EPA-HQ-OECA-2011-0204, which is available for public viewing online at http://www.regulations.gov, or in person viewing at the Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is (202) 566-1744, and the telephone number for the Enforcement and Compliance Docket is (202) 566-1752.Start Printed Page 58270

    Use EPA's electronic docket and comment system at http://www.regulations.gov to either submit or view public comments, access the index listing of the contents of the docket, and to access those documents in the docket that are available electronically. Once in the system, select “docket search,” then key in the docket ID number identified above. Please note that EPA's policy is that public comments, whether submitted electronically or in paper, will be made available for public viewing at http://www.regulations.gov as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. For further information about the electronic docket, go to http://www.regulations.gov.

    Title: NESHAP for Friction Materials Manufacturing (Renewal).

    ICR Numbers: EPA ICR Number 2025.05, OMB Control Number 2060-0481.

    ICR Status: This ICR is schedule to expire on November 30, 2011. Under OMB regulations, the Agency may continue to conduct or sponsor the collection of information while this submission is pending at OMB. An agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB control number. The OMB control numbers for EPA's regulations in title 40 of the CFR, after appearing in the Federal Register when approved, are listed in 40 CFR part 9, and displayed either by publication in the Federal Register or by other appropriate means, such as on the related collection instrument or form, if applicable. The display of OMB control numbers in certain EPA regulations is consolidated in 40 CFR part 9.

    Abstract: The National Emission Standards for Hazardous Air Pollutants (NESHAP) for Friction Materials Manufacturing were proposed on October 4, 2001 (66 FR 50768), and promulgated on October 18, 2002 (67 FR 64498).

    These standards apply to any new, reconstructed, or existing solvent mixers located at any friction materials manufacturing facility engaged in the manufacture of friction materials such as brake and clutch linings. A friction materials manufacturing facility is a major source of hazardous air pollutant (HAP) if it emits or has the potential to emit any single HAP at a rate of 9.07 megagrams (10 tons) or more per year, or any combination of HAP at a rate of 22.68 megagrams (25 tons) or more per year.

    Owners or operators must submit notification reports upon the construction or reconstruction of any friction materials manufacturing facility. Semiannual reports for periods of operation during which the emission limitation has exceeded (or reports certifying that no exceedances have occurred) also are required. Affected entities must retain reports and records for a total of five years: two years at the site, and the remaining three years at an off-site location.

    Notifications are used to inform the Agency or delegated authority when a source becomes subject to the standard. The reviewing authority may then inspect the source to ensure that the pollution control devices are properly installed and that the operating standard is being met. The information generated by monitoring, recordkeeping, and reporting requirements described in this ICR are used by the Agency to ensure that facilities that are affected by the standard continue to operate the control equipment and achieve continuous compliance with the regulation.

    An Agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB Control Number. The OMB Control Number for EPA's regulations are listed in 40 CFR part 9 and 48 CFR chapter 15, and are identified on the form and/or instrument, if applicable.

    Burden Statement: The annual public reporting and recordkeeping burden for this collection of information is estimated to average 162 hours per response. Burden means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose or provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and maintaining information, and disclosing and providing information. All existing ways will have to adjust to comply with any previously applicable instructions and requirements which have subsequently changed; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information.

    Respondents/Affected Entities: Friction materials manufacturing.

    Estimated Number of Respondents: 4.

    Frequency of Response: Annually, semiannually, initially, and occasionally.

    Estimated Total Annual Hour Burden: 1,296.

    Estimated Total Annual Cost: $123,461, which includes $122,373 in labor costs, no capital/startup costs, and $1,088 in operation and maintenance (O&M) costs.

    Changes in the Estimates: There is no change in the labor hours in this ICR as compared to the previous ICR. This situation is due to two considerations: (1) The regulations have not changed over the past three years and are not anticipated to change over the next three years; and (2) the growth rate for the industry is very low, negative, or non-existent, so there is no significant change in the overall burden. There is, however, an increase in the estimated burden cost as currently identified in the OMB Inventory of Approved ICR Burdens. The increase is not due to any program changes. The change in burden cost is due to the use of the most updated labor rates.

    Start Signature

    Dated: September 13, 2011.

    John Moses,

    Director, Collection Strategies Division.

    End Signature End Supplemental Information

    [FR Doc. 2011-24111 Filed 9-19-11; 8:45 am]

    BILLING CODE 6560-50-P

Document Information

Comments Received:
0 Comments
Published:
09/20/2011
Department:
Environmental Protection Agency
Entry Type:
Notice
Action:
Notice.
Document Number:
2011-24111
Dates:
Additional comments may be submitted on or before October 20, 2011.
Pages:
58269-58270 (2 pages)
Docket Numbers:
EPA-HQ-OECA-2011-0204, FRL-9467-2
PDF File:
2011-24111.pdf