2010-24127. Reports, Forms, and Recordkeeping Requirements

AGENCY:

National Highway Traffic Safety Administration (NHTSA), Department of Transportation (DOT).

ACTION:

Request for public comment on proposed collection of information.

SUMMARY:

This notice solicits public comment on continuation of the requirements for the collection of information on safety standards. Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections. This document describes a collection of information for an exisiting regulation for the aftermarket modifications of vehicles to accommodate people with disabilities for which NHTSA intends to seek renewed OMB approval.

DATES:

Comments must be received on or before October 27, 2010.

ADDRESSES:

Comments must refer to the docket notice number cited at the beginning of this notice, and the OMB control number, 2127-0635, and be submitted to the Office of Information and Regulatory Affairs, Office of Management and Budget, Attn: Desk Officer for NHTSA, 725 17th Street, NW., Washington, DC 20503. It is requested, but not required, that 2 copies of the comment be provided.

Commenters may also, but are not required to, submit their comments to the docket number identified in the heading of this document by any of the following methods:

• Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the online instructions for submitting comments.
• Mail: Docket Management Facility, M-30, U.S. Department of Transportation, West Building, Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590
• Hand Delivery or Courier: West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590, between 9 a.m. and 5 p.m. Eastern Time, Monday through Friday, except Federal holidays.
• Fax: [phone].

You may call the Docket Management Facility at 202-366-9826.

Regardless of how you submit your comments, you should mention the docket number of this document.

FOR FURTHER INFORMATION CONTACT:

Complete copies of each request for collection may be obtained from Mrs. Gayle Dalrymple, NVS-123, National Highway Traffic Safety Administration, 1200 New Jersey Ave., SE., Washington, DC 20590. Mrs. Dalrymple's telephone number is [phone].

SUPPLEMENTARY INFORMATION:

On February 27, 2001 NHTSA published a final rule (66 FR 12638) to facilitate the modification of motor vehicles so that persons with disabilities can drive or ride in them as passengers. In that final rule, the agency issued a limited exemption from a statutory provision that prohibits specified types of commercial entities from either removing safety equipment or features installed on motor vehicles pursuant to the Federal motor vehicle safety standards or altering the equipment or features so as to adversely affect their performance. The exemption is limited in that it allows repair businesses to modify only certain types of Federally-required safety equipment and features, under specified circumstances. The regulation is found at 49 CFR part 595 subpart C—Vehicle Modifications to Accommodate People with Disabilities.

This final rule included two new “collections of information,” as that term is defined in 5 CFR part 1320 Controlling Paperwork Burdens on the Public: modifier identification and a document to be provided to the owner of the modified vehicle stating the exemptions used for that vehicle and any reduction in load carrying capacity of the vehicle of more than 100 kg (220 lbs).

Modifiers who take advantage of the exemption created by this rule are required to furnish NHTSA with a written document providing the modifier's name, address, and telephone number, and a statement that the modifier is availing itself of the exemption. The rule requires:

“S595.6 Modifier Identification

(a) Any motor vehicle repair business that modifies a motor vehicle to enable a person with a disability to operate, or ride as a passenger in, the motor vehicle and intends to avail itself of the exemption provided in 49 CFR 595.7 shall furnish the information specified in paragraphs (a)(1) through (3) of this section to: Administrator, National Highway Traffic Safety Administration, 400 Seventh Street, SW., Washington, DC 20590.

(1) Full individual, partnership, or corporate name of the motor vehicle repair business.

(2) Residence address of the motor vehicle repair business and State of incorporation if applicable.

(3) A statement that the motor vehicle repair business modifies a motor vehicle to enable a person with a disability to operate, or ride as a passenger in, the motor vehicle and intends to avail itself of the exemption provided in 49 CFR 595.7.

(b) Each motor vehicle repair business required to submit information under paragraph (a) of this section shall submit the information not later than August 27, 2001. After that date, each motor vehicle repair business that modifies a motor vehicle to enable a person with a disability to operate, or ride as a passenger in, the motor vehicle and intends to avail itself of the exemption provided in 49 CFR 595.7 shall submit the information required under paragraph (a) not later than 30 days after it first modifies a motor vehicle to enable a person with a disability to operate, or ride as a passenger in, the motor vehicle. Each motor vehicle repair business who has submitted required information shall keep its entry current, accurate and compete by submitting revised information not later than 30 days after the relevant changes in the business occur.”

This requirement is a one-time submission unless changes are made to the business as described in paragraph (b). NHTSA estimates that there are currently 471 businesses making modifications to motor vehicles to accommodate persons with disabilities. Of those 471, we estimate 85 percent will need to use the exemptions provided by 49 CFR 595.7 (400 businesses). The initial registration of modifiers wishing to use the exemptions occurred in 2001. Now, we assume that five percent of the 400 businesses currently modifying vehicles will need to change their information or new registrants will elect to use the exemptions. We estimate registrations from 20 businesses each year of: 20 businesses × 10 minutes/business = 3.33 hours.

We estimate the material cost associated with each submission to be 54 cents per responding business, or $10.80 nationwide annually.

Burden means the total time, effort, or financial resources expended by a person to generate, maintain, retain, disclose or provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and maintaining information and disclosing and providing information; adjust the existing ways to comply with any previously applicable instructions and requirements; train personnel to be able to respond to a collection of information; and transmit or otherwise disclose the information.

We seek comment on:

1. Is our estimate of 471 businesses engaged in vehicle modification to accommodate people with disabilities correct?

2. Are we correct in assuming that a maximum of 85 percent of those 471 businesses, or 400 businesses, will need to use the exemptions provided by 49 CFR 595.7?

3. Are our estimates of the burden hours and material cost of compliance with 49 CFR 595.6 reasonable?

Modifiers who avail themselves of the exemptions in 49 CFR 595.7 are required to keep a record, for each applicable vehicle, listing which standards, or portions thereof, no longer comply with the Federal motor vehicle safety standards and to provide a copy to the owner of the vehicle modified (see 49 CFR 595.7(b) and (e) as published in the final rule).

We estimate that:

1. There are approximately 2,700 vehicles modified for persons with disabilities per year by 471 businesses,

2. If 85 percent of the 471 businesses use the exemptions provided by 49 CFR 595.7, those 400 businesses will modify 2,300 vehicles annually, and

3. The burden for producing the record required by 49 CFR 595.7 in accordance with paragraph (e) for those vehicles will be 767 hours per year nationwide.

In the final rule we anticipated that the least costly way for a repair business to comply with this portion of the new rule would be to annotate the vehicle modification invoice as to the exemption, if any, involved with each item on the invoice. The cost of preparing the invoice is not a portion of our burden calculation, as that preparation would be done in the normal course of business. The time needed to annotate the invoice, we estimate, is 20 minutes. Therefore, the burden hours for a full year are calculated as: 2,300 vehicles × 20 minutes/vehicle = 766.7 hours.

This burden includes the calculation required by 49 CFR 595.7(e)5, but not the gathering of the information required for the calculation. That information would be gathered in the normal course of the vehicle modification. The only extra burden required by the rule is the calculation of the reduction in loading carrying capacity and conveying this information to the vehicle owner. Again we are assuming that annotation on the invoice is the least burdensome way to accomplish this customer notification.

There will be no additional material cost associated with compliance with this requirement since no additional materials need be used above those used to prepare the invoice in the normal course of business. We are assuming it is normal and customary in the course of vehicle modification business to prepare an invoice, to provide a copy of the invoice to the vehicle owner, and to keep a copy of the invoice for five years after the vehicle is delivered to the owner in finished form.

We seek comment on whether our assumptions about the following are reasonable:

1. The document required by 49 CFR 595.7(b) and specified in paragraph (e) will need to be prepared for approximately 2,300 vehicles modified nationwide per year,

2. Annotation of each vehicle modification invoice as to which exemptions were used will take an average of 20 minutes, and

3. It is normal in the course of vehicle modification business to prepare an invoice, to provide a copy of the invoice to the vehicle owner, and to keep a copy of the invoice for five years after the vehicle is delivered to the owner in finished form.

Affected Public: Business or other for profit.

Estimated Annual Burden: 770 hours, and $10.80.

Estimated Number of Respondents: 400.

Comments are invited on: Whether the proposed collection of information is necessary for the proper performance of the functions of the Department, including whether the information will have practical utility; the accuracy of the Department's estimate of the burden of the proposed information collection; ways to enhance the quality, utility and clarity of the information to be collected; and ways to minimize the burden of the collection of information on respondents, including the use of automated collection techniques or other forms of information technology.

Issued on: September 22, 2010.

Nathaniel M. Beuse,

Office of Crash Avoidance Standards, Director.