2017-19018. Airworthiness Directives; General Electric Company Turbofan Engines

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

We propose to adopt a new airworthiness directive (AD) for certain General Electric Company (GE) CF6-80A, CF6-80A1, CF6-80A2, CF6-80A3, CF6-80C2A1, CF6-80C2A2, CF6-80C2A3, CF6-80C2A5, CF6-80C2A5F, CF6-80C2A8, CF6-80C2B1, CF6-80C2B1F, CF6-80C2B1F1, CF6-80C2B1F2, CF6-80C2B2, CF6-80C2B2F, CF6-80C2B3F, CF6-80C2B4, CF6-80C2B4F, CF6-80C2B5F, CF6-80C2B6, CF6-80C2B6F, CF6-80C2B6FA, CF6-80C2B7F, CF6-80C2B8F, CF6-80C2D1F, CF6-80C2L1F, and CF6-80C2K1F turbofan engines. This proposed AD was prompted by an uncontained failure of a high-pressure turbine (HPT) stage 2 disk. This proposed AD would require ultrasonic inspection (UI) of HPT stage 1 and 2 disks. We are proposing this AD to address the unsafe condition on these products.

DATES:

We must receive comments on this proposed AD by October 23, 2017.

ADDRESSES:

You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

• Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
• Fax: [phone].
• Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

For service information identified in this NPRM, contact General Electric Company, GE Aviation, Room 285, 1 Neumann Way, Cincinnati, OH 45215; phone: [phone]; email: [e-mail]. You may view this service information at the FAA, Engine and Propeller Standards Branch, 1200 District Avenue, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0792; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (phone: [phone]) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT:

Herman Mak, Aerospace Engineer, FAA, ECO Branch, Compliance and Airworthiness Division, 1200 District Ave., Burlington, MA 01803; phone: [phone]; fax: [phone]; email: [e-mail].

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2017-0792; Product Identifier 2017-NE-28-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this NPRM. We will consider all comments received by the closing date and may amend this NPRM because of those comments.

We will post all comments we receive, without change, to http://www.regulations.gov,, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this NPRM.

Discussion

We became aware of an unsafe condition from an uncontained failure of an HPT stage 2 disk that resulted in a fire. This unsafe condition was also determined to exist on some HPT stage 1 disks. This condition, if not corrected, could result in uncontained HPT disk release, damage to the engine, and damage to the airplane.

Related Service Information Under 1 CFR Part 51

We reviewed GE Service Bulletin (SB) CF6-80C2 S/B 72-1562, Revision 01, dated July 28, 2017. The SB describes procedures for UI of HPT stage 1 and 2 disks. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

FAA's Determination

We are proposing this AD because we evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.

Proposed AD Requirements

This proposed AD would require UI of HPT stage 1 and 2 disks.

Costs of Compliance

We estimate that this proposed AD affects 640 engines installed on airplanes of U.S. registry.

We estimate the following costs to comply with this proposed AD:

Estimated Costs

Action	Labor cost	Parts cost	Cost per product	Cost on U.S. operators
UI of HPT disk	10 work-hours × $85 per hour = $850	$0	$850	$544,000

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

This AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to engines, propellers, and associated appliances to the Manager, Engine and Propeller Standards Branch, Policy and Innovation Division.

Regulatory Findings

We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed regulation:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

General Electric Company: Docket No. FAA-2017-0792; Product Identifier 2017-NE-28-AD.

(a) Comments Due Date

We must receive comments by October 23, 2017.

(b) Affected ADs

None.

(c) Applicability

This AD applies to General Electric Company (GE) CF6-80A, CF6-80A1, CF6-80A2, CF6-80A3, CF6-80C2A1, CF6-80C2A2, CF6-80C2A3, CF6-80C2A5, CF6-80C2A5F, CF6-80C2A8, CF6-80C2B1, CF6-80C2B1F, CF6-80C2B1F1, CF6-80C2B1F2, CF6-80C2B2, CF6-80C2B2F, CF6-80C2B3F, CF6-80C2B4, CF6-80C2B4F, CF6-80C2B5F, CF6-80C2B6, CF6-80C2B6F, CF6-80C2B6FA, CF6-80C2B7F, CF6-80C2B8F, CF6-80C2D1F, CF6-80C2L1F, and CF6-80C2K1F turbofan engines with high-pressure turbine (HPT) disks with part numbers and serial numbers listed in Table 1 and 2 of Appendix A in GE Service Bulletin (SB) CF6-80C2 S/B 72-1562, Revision 01, dated July 28, 2017.

(d) Subject

Joint Aircraft System Component (JASC) Code 7250, Turbine/Turboprop Engine—Turbine Section.

(e) Unsafe Condition

This AD was prompted by an uncontained failure of a HPT stage 2 disk. We are issuing this AD to prevent failure of the HPT disks. The unsafe condition, if not corrected, could result in an uncontained HPT disk release, damage to the engine, and damage to the airplane.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Required Actions

After the effective date of this AD, perform an ultrasonic inspection for cracks in stage 1 and stage 2 HPT disk at each piece-part level exposure in accordance with the Accomplishment Instructions, paragraph 3.A.(2) of GE SB CF6-80C2 S/B 72-1562, Revision 01, dated July 28, 2017.

(h) Definition

For the purpose of this AD, “piece-part exposure” of the stage 1 or 2 disk is removal of that disk from the engine and removal of all blades from that disk.

(i) Alternative Methods of Compliance (AMOCs)

(1) The Manager, FAA, ECO Branch, Compliance and Airworthiness Division, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ECO Branch, send it to the attention of the person identified in paragraph (j)(1) of this AD. You may email your request to: [e-mail].

(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(j) Related Information

(1) For more information about this AD, contact Herman Mak, Aerospace Engineer, Aerospace Engineer, FAA, ECO Branch, Compliance and Airworthiness Division, 1200 District Avenue, Burlington, MA 01803; phone: [phone]; fax: [phone]; email: [e-mail].

(2) For service information identified in this AD, contact General Electric Company, GE Aviation, Room 285, 1 Neumann Way, Cincinnati, OH 45215; phone: [phone]; email: [e-mail].

(3) You may view this referenced service information at the FAA, Engine and Propeller Standards Branch, Policy and Innovation Division, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-238-7125.

Issued in Burlington, Massachusetts, on September 1, 2017.

Robert J. Ganley,

Manager, Engine and Propeller Standards Branch, Aircraft Certification Service.