2017-19016. Reports, Forms, and Recordkeeping Requirements

AGENCY:

National Highway Traffic Safety Administration (NHTSA), U.S. Department of Transportation (DOT).

ACTION:

Request for public comment on extension of a currently approved collection of information.

SUMMARY:

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections. This document describes an existing collection of information for an existing regulation for the aftermarket modification of vehicles to accommodate people with disabilities, for which NHTSA intends to seek renewed OMB approval.

DATES:

Comments must be received on or before November 7, 2017.

ADDRESSES:

Comments must refer to the docket number cited at the beginning of this notice, and may be submitted by any of the following methods:

• Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the online instructions for submitting comments.
• Mail: Docket Management Facility, M-30, U.S. Department of Transportation, West Building, Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
• Hand Delivery or Courier: West Building, Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590, between 9 a.m. and 5 p.m. Eastern Time, Monday through Friday, except Federal holidays. Telephone: [phone].
• Instructions: All submissions must include the docket number for this document. Please identify the collection of information for which a comment is provided by referencing the OMB Control Number, 2127-0635. Note that all comments received will be posted without change to http://www.regulations.gov,, including any personal information provided. Please see the Privacy Act heading below.

Privacy Act: Anyone is able to search the electronic form of all comments received into any of our dockets by title name of the individual submitting the comment (or signing the comment, if submitted on behalf of an association, business, labor union, etc.). You may review DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78) or you may visit http://DocketsInfo.dot.gov.

FOR FURTHER INFORMATION CONTACT:

Mr. Christopher J. Wiacek, NHTSA, 1200 New Jersey Avenue SE., Room W43-474, NVS-122, Washington, DC 20590. Mr. Wiacek's telephone number is [phone].

SUPPLEMENTARY INFORMATION:

Under the Paperwork Reduction Act of 1995, before an agency submits a proposed collection of information to OMB for approval, it must first publish a document in the Federal Register providing a 60-day comment period and otherwise consult with members of the public and affected agencies concerning each proposed collection of information. The OMB has promulgated regulations describing what must be included in such a document. Under OMB's regulation (at 5 CFR 1320.8(d)), an agency must ask for public comment on the following:

(1) Whether the proposed collection of information is necessary for the proper performance of the functions of the agency, including whether the information will have practical utility;

(2) The accuracy of the agency's estimate of the burden of the proposed collection of information, including the validity of the methodology and assumptions used;

(3) How to enhance the quality, utility, and clarity of the information to be collected;

(4) How to minimize the burden of the collection of information on those who are to respond, including the use of appropriate automated, electronic, mechanical, or other technological collection techniques or other forms of information technology, e.g., permitting electronic submission of responses.

In compliance with these requirements, NHTSA asks for public comments on the following collection of information:

Title: Exemption for the Make Inoperative Prohibition.

OMB Control Number: 2127-0635.

Form Number: This collection of information uses no standard form.

Type of Request: Extension of a currently approved collection of information.

Abstract: On February 27, 2001, NHTSA published a final rule (66 FR 12638) to facilitate the modification of motor vehicles so that persons with disabilities can drive or ride in them as passengers. In that final rule, the agency issued a limited exemption from a statutory provision that prohibits specified types of commercial entities from either removing safety equipment or features installed on motor vehicles pursuant to the Federal motor vehicle safety standards or altering the equipment or features so as to adversely affect their performance. The exemption is limited in that it allows repair businesses to modify only certain types of Federally-required safety equipment and features, under specified circumstances. The regulation is found at 49 CFR part 595 subpart C, “Vehicle Modifications to Accommodate People with Disabilities.”

This final rule included two new “collections of information,” as that term is defined in 5 CFR part 1320 “Controlling Paperwork Burdens on the Public”: Modifier identification and a document to be provided to the owner of the modified vehicle stating the exemptions used for that vehicle and any reduction in load carrying capacity of the vehicle of more than 100 kg (220 lbs).

Modifiers who take advantage of the exemption created by this rule are required to furnish NHTSA with a written document providing the modifier's name, address, and telephone number, and a statement that the modifier is availing itself of the exemption. The rule requires:

“S595.6 Modifier Identification.

(a) Any motor vehicle repair business that modifies a motor vehicle to enable a person with a disability to operate, or ride as a passenger in, the motor vehicle and intends to avail itself of the exemption provided in 49 CFR 595.7 shall furnish the information specified in paragraphs (a)(1) through (3) of this section to: Administrator, National Highway Traffic Safety Administration, 400 Seventh Street SW., Washington, DC 20590.^[1]

(1) Full individual, partnership, or corporate name of the motor vehicle repair business.

(2) Residence address of the motor vehicle repair business and State of incorporation if applicable.

(3) A statement that the motor vehicle repair business modifies a motor vehicle to enable a person with a disability to operate, or ride as a passenger in, the motor vehicle and intends to avail itself of the exemption provided in 49 CFR 595.7.

(b) Each motor vehicle repair business required to submit information under paragraph (a) of this section shall submit the information not later than August 27, 2001. After that date, each motor vehicle repair business that modifies a motor vehicle to enable a person with a disability to operate, or ride as a passenger in, the motor vehicle and intends to avail itself of the exemption provided in 49 CFR 595.7 shall submit the information required under paragraph (a) not later than 30 days after it first modifies a motor vehicle to enable a person with a disability to operate, or ride as a passenger in, the motor vehicle. Each motor vehicle repair business who has submitted required information shall keep its entry current, accurate and complete by submitting revised information not later than 30 days after the relevant changes in the business occur.”

This requirement is a one-time submission unless changes are made to the business as described in paragraph (b). NHTSA estimates that there are currently 900 businesses making modifications to motor vehicles to accommodate persons with disabilities. Of those 900, we estimate 85 percent will need to use the exemptions provided by 49 CFR 595.7 (595 businesses). The initial registration of modifiers wishing to use the exemptions occurred in 2001. Based on letters received since then, we estimate that 90 businesses currently modifying vehicles will need to change their information or new registrants will elect to use the exemptions annually. We estimate the burden of new or changed registrations from 90 businesses each year of:

90 businesses × 10 minutes/business = 15 hours.

We estimate the material cost associated with each submission to be 56 cents per responding business, or $50.04 nationwide annually.

Burden means the total time, effort, or financial resources expended by a person to generate, maintain, retain, disclose or provide information to or for a Federal agency. This includes the time needed to review instruction; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and maintaining information and disclosing and providing information; adjust the existing ways to comply with any previously applicable instructions and requirements; train personnel to be able to respond to a collection of information; and transmit or otherwise disclose the information.

We seek comment on:

1. Is our estimate of 900 businesses engaged in vehicle modification to accommodate people with disabilities correct?

2. Are we correct in assuming that a maximum of 85 percent of those 900 businesses, or 765 businesses, will need to use the exemptions provided by 49 CFR 595.7?

3. Are our estimates of the burden hours and material cost of compliance with 49 CFR 595.6 reasonable?

Modifiers who avail themselves of the exemptions in 49 CFR 595.7 are required to keep a record, for each applicable vehicle, listing which standards, or portions thereof, no longer comply with the Federal motor vehicle safety standards and to provide a copy to the owner of the vehicle modified (see 49 CFR 595.7(b) and (e) as published in the final rule).

We estimate that:

1. There are approximately 5,000 vehicles modified for persons with disabilities per year by 900 businesses; ^[2]

2. If 85 percent of the 900 businesses use the exemptions provided by 49 CFR 595.7, those 765 businesses will modify 4,383 vehicles annually; and

3. The burden for producing the record required by 49 CFR 595.7 in accordance with paragraph (e) for those vehicles will be 1,460 hours per year nationwide.

In the final rule we anticipated that the least costly way for a repair business to comply with this portion of the new rule would be to annotate the vehicle modification invoice as to the exemption, if any, involved with each item on the invoice. The cost of preparing the invoice is not a portion of our burden calculation, as that preparation would be done in the normal course of business. The time needed to annotate the invoice, we estimate, is 20 minutes. Therefore, the burden hours for a full year are calculated as:

4,383 vehicles × 20 minutes/vehicle = 1,460 hours.

This burden includes the calculation required by 49 CFR 595.7(e), but not the gathering of the information required for the calculation. That information would be gathered in the normal course of the vehicle modification. The only extra burden required by the rule is the calculation of the reduction in loading carrying capacity and conveying this information to the vehicle owner. Again, we are assuming that annotation on the invoice is the least burdensome way to accomplish this customer notification.

There will be no additional material cost associated with compliance with this requirement since no additional materials need be used above those used to prepare the invoice in the normal course of business. We are assuming it is normal and customary in the course of vehicle modification business to prepare an invoice, to provide a copy of the invoice to the vehicle owner, and to keep a copy of the invoice for five years after the vehicle is delivered to the owner in finished form.

We seek comment on whether our assumptions about the following are accurate:

1. The document required by 49 CFR 595.7(b) and specified in paragraph (e) will need to be prepared for approximately 4,383 vehicles modified nationwide per year,

2. Annotation of each vehicle modification invoice as to which exemptions were used will take an average of 20 minutes, and

3. It is normal in the course of vehicle modification business to prepare an invoice, to provide a copy of the invoice to the vehicle owner, and to keep a copy of the invoice for five years after the vehicle is delivered to the owner in finished form.

Affected Public: Business or other for profit.

Estimated Annual Burden: 1,475 hours, and $50.04.

Estimated Number of Respondents: 765.

Comments are invited on: Whether the proposed collection of information is necessary for the proper performance of the functions of the Department, including whether the information will have practical utility; the accuracy of the Department's estimate of the burden of the proposed information collection; ways to enhance the quality, utility and clarity of the information to be collected; and ways to minimize the burden of the collection of information on respondents, including the use of automated collection techniques or other forms of information technology.

Raymond R. Posten,

Associate Administrator for Rulemaking.

Footnotes

1.  The address of NHTSA has changed since 2001 and is now 1200 New Jersey Ave. SE., Washington, DC 20590.

2.  The agency does not require modifiers to submit information to us for every vehicle that is modified. Therefore, we have no exact count of the number of modifications made each year.