04-24630. Airworthiness Directives; Raytheon Aircraft Company Model B100 Airplanes  

  • Start Preamble

    AGENCY:

    Federal Aviation Administration (FAA), DOT.

    ACTION:

    Final rule.

    SUMMARY:

    The FAA adopts a new airworthiness directive (AD) for certain Raytheon Aircraft Company (Raytheon) Model B100 airplanes. This AD requires you to drill holes in the hot lip tube “B” nuts, tighten the “B” nuts to specified torque ranges, and secure the “B” nuts with safety wire. This AD is the result of reports of loose “B” nuts on the engine inlet that may loosen and permit a leak in the engine inlet anti-ice system. We are issuing this AD to detect and correct loose “B” nuts on the engine inlet, which could result in failure of the engine inlet anti-ice system and consequent ice buildup. This failure and ice buildup could lead to an engine's ingestion of ice with loss of engine power or loss of engine.

    DATES:

    This AD becomes effective on December 27, 2004.

    As of December 27, 2004, the Director of the Federal Register approved the incorporation by reference of certain publications listed in the regulation.

    ADDRESSES:

    You may get the service information identified in this AD from Raytheon Aircraft Company, 9709 E. Central, Wichita, Kansas 67201-0085; telephone: (800) 429-5372 or (316) 676-3140.

    You may view the AD docket at FAA, Central Region, Office of the Regional Counsel, Attention: Rules Docket No. 2004-CE-11-AD, 901 Locust, Room 506, Kansas City, Missouri 64106. Office hours are 8 a.m. to 4 p.m., Monday through Friday, except Federal holidays.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Jeff Pretz, Aerospace Engineer, Wichita Aircraft Certification Office, FAA, 1801 Airport Road, Wichita, Kansas 67209; telephone: (316) 946-4153; facsimile: (316) 946-4407.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Discussion

    What events have caused this AD? The FAA has received six reports of loose “B” nuts on the Raytheon Model B100 engine inlet anti-ice system found during routine maintenance. These loose “B” nuts may permit a leak in the engine inlet anti-ice system that would result in failure of the system with consequent ice buildup on the engine inlet.

    What is the potential impact if FAA took no action? Failure of the engine inlet anti-ice system and consequent ice buildup could lead to an engine's ingestion of ice with loss of engine power or loss of engine.

    Has FAA taken any action to this point? We issued a proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an AD that would apply to certain Raytheon Model B100 airplanes. This proposal was published in the Federal Register as a notice of proposed rulemaking (NPRM) on May 26, 2004 (69 FR 29910). The NPRM proposed to require you to drill holes in the hot lip tube “B” nuts, tighten the “B” nuts to specified torque ranges, and secure the “B” nuts with safety wire.

    Comments

    Was the public invited to comment? We provided the public the opportunity to participate in developing this AD. We received no comments on the proposal or on the determination of the cost to the public.

    Conclusion

    What is FAA's final determination on this issue? We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed except for minor editorial corrections. We have determined that these minor corrections:

    —Are consistent with the intent that was proposed in the NPRM for correcting the unsafe condition; and

    —Do not add any additional burden upon the public than was already proposed in the NPRM.

    Changes to 14 CFR Part 39—Effect on the AD

    How does the revision to 14 CFR part 39 affect this AD? On July 10, 2002, the FAA published a new version of 14 CFR part 39 (67 FR 47997, July 22, 2002), which governs the FAA's AD system. This regulation now includes material that relates to altered products, special Start Printed Page 64859flight permits, and alternative methods of compliance. This material previously was included in each individual AD. Since this material is included in 14 CFR part 39, we will not include it in future AD actions.

    Costs of Compliance

    How many airplanes does this AD impact? We estimate that this AD affects 96 airplanes in the U.S. registry.

    What is the cost impact of this AD on owners/operators of the affected airplanes? We estimate the following costs to do the inspection and modification:

    Labor costParts costTotal cost per airplaneTotal cost on U.S. operators
    4 workhours × $65 per hour = $260Not Applicable$260$24,960

    Regulatory Findings

    Will this AD impact various entities? We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

    Will this AD involve a significant rule or regulatory action? For the reasons discussed above, I certify that this AD:

    1. Is not a “significant regulatory action” under Executive Order 12866;

    2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

    3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    We prepared a summary of the costs to comply with this AD and placed it in the AD Docket. You may get a copy of this summary by sending a request to us at the address listed under ADDRESSES. Include “AD Docket No. 2004-CE-11-AD” in your request.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    Adoption of the Amendment

    Start Amendment Part

    Accordingly, under the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

    End Amendment Part Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. FAA amends § 39.13 by adding a new AD to read as follows:

    End Amendment Part

    2004-22-28 Raytheon Aircraft Company: Amendment 39-13856; Docket No. 2004-CE-11-AD.

    When Does This AD Become Effective?

    (a) This AD becomes effective on December 27, 2004.

    What Other ADs Are Affected by This Action?

    (b) None.

    What Airplanes Are Affected by This AD?

    (c) This AD affects Model B100 airplanes, serial numbers BE-1 through BE-136, that are certificated in any category.

    What Is the Unsafe Condition Presented in This AD?

    (d) This AD is the result of reports of loose “B” nuts on the engine inlet that may loosen and permit a leak in the engine inlet anti-ice system. The actions specified in this AD are intended to detect and correct loose “B” nuts on the engine inlet, which could result in failure of the engine inlet anti-ice system and consequent ice buildup. This failure and ice buildup could lead to an engine's ingestion of ice with loss of engine power or loss of engine.

    What Must I Do To Address This Problem?

    (e) To address this problem, you must do the following:

    ActionsComplianceProcedures
    (1) Drill a 0.035-inch hole in each of the hot tube “B” nuts (part number (P/N) AN818-6D and AN818-8D).Within the next 150 hours time-in-service (TIS) or 6 calendar months after December 27, 2004 (the effective date of this AD), whichever occurs first.Follow Raytheon Aircraft Mandatory Service Bulletin No. SB 30-3143, dated September 2001. The applicable airplane maintenance manual also addresses this issue.
    (2) Tighten the hot lip tube “B” nuts to a specified torque range: (i) Tighten hot lip tube “B” nuts P/N AN818-6D to a torque range of 75 to 125 inch-pounds. (ii) Tighten hot lip tube “B” nuts P/N AN818-8D to a torque range of 150 to 250 inch-pounds.Before further flight after the actions required by paragraph (e)(1) of the AD.Follow Raytheon Aircraft Mandatory Service Bulletin No. SB 30-3143, dated September 2001. The applicable airplane maintenance manual also addresses this issue.
    (3) Secure the hot lip tube “B” nuts (P/N AN818-6D and AN818-8D) with safety wire.Before further flight after the actions required by paragraph (e)(2) of this AD.Follow Raytheon Aircraft Mandatory Service Bulletin No. SB 30-3143, dated September 2001. The applicable airplane maintenance manual also addresses this issue.

    May I Request an Alternative Method of Compliance?

    (f) You may request a different method of compliance or a different compliance time for this AD by following the procedures in 14 CFR 39.19. Unless FAA authorizes otherwise, send your request to your principal inspector. The principal inspector may add comments and will send your request to the Manager, Wichita Aircraft Certification Office (ACO), FAA. For information on any already approved alternative methods of compliance, contact Jeff Pretz, Aerospace Engineer, Wichita ACO, FAA, 1801 Airport Road, Wichita, Kansas 67209; telephone: (316) 946-4153; facsimile: (316) 946-4407.

    Does This AD Incorporate Any Material by Reference?

    (g) You must do the actions required by this AD following the instructions in Raytheon Aircraft Mandatory Service Bulletin No. SB 30-3143, dated September 2001. The Director of the Federal Register approved the incorporation by reference of Start Printed Page 64860this service bulletin in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. You may get a copy from Raytheon Aircraft Company, 9709 E. Central, Wichita, Kansas 67201-0085; telephone: (800) 429-5372 or (316) 676-3140. You may review copies at FAA, Central Region, Office of the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri 64106; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/​federal_​register/​code_​of_​federal_​regulations/​ibr_​locations.html.

    Start Signature

    Issued in Kansas City, Missouri, on October 27, 2004.

    David R. Showers,

    Acting Manager, Small Airplane Directorate, Aircraft Certification Service.

    End Signature End Supplemental Information

    [FR Doc. 04-24630 Filed 11-8-04; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Effective Date:
12/27/2004
Published:
11/09/2004
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final rule.
Document Number:
04-24630
Dates:
This AD becomes effective on December 27, 2004.
Pages:
64858-64860 (3 pages)
Docket Numbers:
Docket No. 2004-CE-11-AD, Amendment 39-13856, AD 2004-22-28
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
04-24630.pdf
CFR: (1)
14 CFR 39.13