04-7285. Airworthiness Directives; Bombardier Model DHC-8-102, -103, -106, -201, -202, -301, -311, and -315 Airplanes

AGENCY:

Federal Aviation Administration, DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

This document proposes the adoption of a new airworthiness directive (AD) that is applicable to Bombardier Model DHC-8-102, -103, -106, -201, -202, -301, -311, and -315 airplanes. This proposal would require rework/retrofit of the wardrobe shelf assembly. This action is necessary to prevent the wardrobe shelf and attached equipment separating from the attachment in the event of a hard landing, which could impede the egress of passengers in the event of an emergency evacuation. This action is intended to address the identified unsafe condition.

DATES:

Comments must be received by May 3, 2004.

ADDRESSES:

Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-331-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9 a.m. and 3 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to [phone]. Comments may also be sent via the Internet using the following address: [e-mail]. Comments sent via fax or the Internet must contain “Docket No. 2001-NM-331-AD” in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 or 2000 or ASCII text.

The service information referenced in the proposed rule may be obtained from Bombardier, Inc., Bombardier Regional Aircraft Division, 123 Garratt Boulevard, Downsview, Ontario M3K 1Y5, Canada. This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, New York Aircraft Certification Office, 1600 Stewart Avenue, suite 410, Westbury, New York.

FOR FURTHER INFORMATION CONTACT:

Leung Lee, Aerospace Engineer, Systems and Flight Test Branch, ANE-172, FAA, New York Aircraft Certification Office, 1600 Stewart Avenue, Westbury, Suite 410, New York 11590; telephone [phone]; fax [phone].

SUPPLEMENTARY INFORMATION:

Comments Invited

Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received.

Submit comments using the following format:

• Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.
• For each issue, state what specific change to the proposed AD is being requested.
• Include justification (e.g., reasons or data) for each request.

Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: “Comments to Docket Number 2001-NM-331-AD.” The postcard will be date stamped and returned to the commenter.

Availability of NPRMs

Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-331-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.

Discussion

Transport Canada Civil Aviation (TCCA), which is the airworthiness authority for Canada, notified the FAA that an unsafe condition may exist on certain Bombardier Model DHC-8-102, -103, -106, -201, -202, -301, -311, and -315 airplanes. TCCA advises that the retention system of the upper wardrobe shelf attachments was found to be under strength. This condition, if not corrected, could result in the wardrobe shelf and attached equipment separating from the attachment in the event of a hard landing, which could impede the egress of passengers in the event of an emergency evacuation.

Explanation of Relevant Service Information

Bombardier has issued Service Bulletin 8-25-311, Revision ‘B,’ dated December 15, 2000, which describes procedures for rework/retrofit of the wardrobe shelf assembly. Accomplishment of the actions specified in the service bulletin is intended to address the identified unsafe condition. TCCA classified this service bulletin as mandatory and issued Canadian airworthiness directive CF-2001-17, effective June 15, 2001, to ensure the continued airworthiness of these airplanes in Canada.

FAA's Conclusions

These airplane models are manufactured in Canada and are type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, TCCA has kept the FAA informed of the situation described above. The FAA has examined the findings of TCCA, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.

Explanation of Requirements of Proposed Rule

Since an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design registered in the United States, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously.

Cost Impact

The FAA estimates that 18 airplanes of U.S. registry would be affected by this proposed AD, that it would take approximately 20 work hours per airplane to accomplish the proposed actions, and that the average labor rate is $65 per work hour. Required parts would cost approximately $1,387 per airplane. Based on these figures, the cost impact of the proposed AD on U.S. operators is estimated to be $48,366, or $2,687 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this proposed regulation (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Safety

The Proposed Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

Bombardier, Inc. (Formerly de Havilland, Inc.): Docket 2001-NM-331-AD.

Applicability: Model DHC-8-102, -103, -106, -201, -202, -301, -311, and -315 airplanes, serial numbers 452, 464, 490, 506, 508 through 531 inclusive, and 535; certificated in any category.

Compliance: Required as indicated, unless accomplished previously.

To prevent the wardrobe shelf and attached equipment separating from the attachment in the event of a hard landing, which could impede the egress of passengers in the event of an emergency evacuation, accomplish the following:

Rework/Retrofit

(a) Within 12 months after the effective date of this AD, rework/retrofit the wardrobe shelf assembly per the Accomplishment Instructions of Bombardier Service Bulletin 8-25-311, Revision ‘B,’ dated December 15, 2000.

(b) Rework/retrofit of the wardrobe shelf assembly accomplished before the effective date of this AD per Bombardier Service Bulletin 8-25-311, dated December 14, 1999; or Revision ‘A,’ dated February 8, 2000; is acceptable for compliance with the requirements of paragraph (a) of this AD.

Alternative Methods of Compliance

(c) In accordance with 14 CFR 39.19, the Manager, New York Aircraft Certification Office, FAA, is authorized to approve alternative methods of compliance (AMOC) for this AD.

Note 1:

The subject of this AD is addressed in Canadian airworthiness directive CF-2001-17, effective June 15, 2001.

Issued in Renton, Washington, on March 24, 2004.

Kalene C. Yanamura,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.