2010-33334. Airworthiness Directives; Dassault-Aviation Model FALCON 7X Airplanes  

  • Start Preamble

    AGENCY:

    Federal Aviation Administration (FAA), DOT.

    ACTION:

    Notice of proposed rulemaking (NPRM).

    SUMMARY:

    We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

    A design review has revealed a potential dormant failure of the Ram Air Turbine (RAT) heating system. If this failure occurs, it could lead to the freezing of the RAT mechanism and the consequent non-deployment of the RAT when needed.

    * * * * *

    Non-deployment of the RAT could result in insufficient electrical power to operate the fly-by-wire system, and Start Printed Page 481subsequent loss of control of the airplane. The proposed AD would require actions that are intended to address the unsafe condition described in the MCAI.

    DATES:

    We must receive comments on this proposed AD by February 22, 2011.

    ADDRESSES:

    You may send comments by any of the following methods:

    • Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
    • Fax: (202) 493-2251.
    • Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590.
    • Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

    Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov;​; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Comments Invited

    We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2010-1306; Directorate Identifier 2010-NM-112-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.

    We will post all comments we receive, without change, to http://www.regulations.gov,, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.

    Discussion

    The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA Airworthiness Directive 2010-0033, dated March 3, 2010 (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:

    A design review has revealed a potential dormant failure of the Ram Air Turbine (RAT) heating system. If this failure occurs, it could lead to the freezing of the RAT mechanism and the consequent non-deployment of the RAT when needed.

    The purpose of this AD is to require a repetitive functional test of the RAT heater * * *.

    Non-deployment of the RAT could result in insufficient electrical power to operate the fly-by-wire system, and subsequent loss of control of the airplane. The corrective action is repairing using a method approved by either the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA) (or its delegated agent). You may obtain further information by examining the MCAI in the AD docket.

    FAA's Determination and Requirements of This Proposed AD

    This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.

    Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

    We might also have proposed different actions in this AD from those in the MCAI in order to follow FAA policies. Any such differences are highlighted in a Note within the proposed AD.

    Costs of Compliance

    Based on the service information, we estimate that this proposed AD would affect about 21 products of U.S. registry. We also estimate that it would take about 1 work-hour per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $1,785, or $85 per product.

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

    We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    Regulatory Findings

    We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify this proposed regulation:

    1. Is not a “significant regulatory action” under Executive Order 12866;

    2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

    3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.Start Printed Page 482

    We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Safety
    End List of Subjects

    The Proposed Amendment

    Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

    Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]

    2. The FAA amends § 39.13 by adding the following new AD:

    Dassault-Aviation: Docket No. FAA-2010-1306; Directorate Identifier 2010-NM-112-AD.

    Comments Due Date

    (a) We must receive comments by February 22, 2011.

    Affected ADs

    (b) None.

    Applicability

    (c) This AD applies to Dassault-Aviation Model FALCON 7X airplanes, certificated in any category, all serial numbers.

    Subject

    (d) Air Transport Association (ATA) of America Code 24: Electrical power.

    Reason

    (e) The mandatory continuing airworthiness information (MCAI) states:

    A design review has revealed a potential dormant failure of the Ram Air Turbine (RAT) heating system. If this failure occurs, it could lead to the freezing of the RAT mechanism and the consequent non-deployment of the RAT when needed.

    * * * * *

    Non-deployment of the RAT could result in insufficient electrical power to operate the fly-by-wire system, and subsequent loss of control of the airplane.

    Compliance

    (f) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

    Actions

    (g) At the applicable times specified in paragraph (g)(1) or (g)(2) of this AD, do a functional test of the RAT heater using a method approved by either the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA) (or its delegated agent). Repeat the functional test of the RAT heater thereafter at the applicable time specified in paragraph (g)(1) or (g)(2) of this AD. If any functional test fails, before further flight, repair using a method approved by either the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or EASA (or its delegated agent).

    (1) For Falcon 7X airplanes on which modification M0305 has not been done and on which Dassault Service Bulletin 7X-018, dated March 6, 2009, has not been done: Within 650 flight hours after the effective date of this AD, do a functional test of the RAT heater and repeat the functional test of the RAT heater thereafter at intervals not to exceed 650 flight hours.

    (2) For Falcon 7X airplanes on which modification M0305 has been done or on which Dassault Service Bulletin 7X-018, dated March 6, 2009, has been done: Within 1,900 flight hours after the effective date of this AD or after modification M0305 or Dassault Service Bulletin 7X-018, dated March 6, 2009, has been done, whichever occurs later, do a functional test of the RAT heater: Repeat the functional test of the RAT heater thereafter at intervals not to exceed 1,900 flight hours.

    Note 1:

    Additional guidance for doing the functional test of the RAT heater required by paragraph (g) of this AD can be found in Task 24-50-25-720-801, Functional Test of the RAT Heater, dated January 16, 2009, of the Dassault Falcon 7X Aircraft Maintenance Manual (AMM).

    FAA AD Differences

    Note 2:

    This AD differs from the MCAI and/or service information as follows:

    (1) The MCAI provides an option of inserting the MCAI into the Falcon 7X AMM Chapter 5-40, pending publication of the revised AMM Chapter 5-40. This AD does not have that option.

    (2) The MCAI requires doing the actions in accordance with Maintenance Task 24-50-25-720-801, Chapter 5-40, of the Dassault Falcon 7X AMM. However, this AD requires that the actions be done using a method approved by the FAA or EASA (or its delegated agent).

    Other FAA AD Provisions

    (h) The following provisions also apply to this AD:

    (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD.

    (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

    (3) Reporting Requirements: A Federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 5 minutes per response, including the time for reviewing instructions, completing and reviewing the collection of information. All responses to this collection of information are mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at: 800 Independence Ave., SW., Washington, DC 20591, Attn: Information Collection Clearance Officer, AES-200.

    Related Information

    (i) Refer to MCAI EASA Airworthiness Directive 2010-0033, dated March 3, 2010, for related information.

    Start Signature

    Issued in Renton, Washington, on December 27, 2010.

    Jeffrey E. Duven,

    Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

    End Signature End Part End Supplemental Information

    [FR Doc. 2010-33334 Filed 1-4-11; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Comments Received:
0 Comments
Published:
01/05/2011
Department:
Federal Aviation Administration
Entry Type:
Proposed Rule
Action:
Notice of proposed rulemaking (NPRM).
Document Number:
2010-33334
Dates:
We must receive comments on this proposed AD by February 22, 2011.
Pages:
480-482 (3 pages)
Docket Numbers:
Docket No. FAA-2010-1306, Directorate Identifier 2010-NM-112-AD
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Safety
PDF File:
2010-33334.pdf
CFR: (1)
14 CFR 39.13