2017-15555. Airworthiness Directives; Bombardier, Inc. (Type Certificate Previously Held by Canadair Limited) Airplanes

AGENCY:

Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION:

Final rule.

SUMMARY:

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-215-6B11 (CL-415 Variant) airplanes. This AD was prompted by a report indicating that an oxygen bottle was found loose while the clamp strap was in the locked position. This AD requires modification of the clamp strap and installation of additional shims, as applicable, to the flight crew's oxygen bottles' retaining structures. We are issuing this AD to address the unsafe condition on these products.

DATES:

This AD is effective September 5, 2017.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of September 5, 2017.

ADDRESSES:

For service information identified in this final rule, contact Bombardier, Inc., 400 Côte-Vertu Road West, Dorval, Québec H4S 1Y9, Canada; telephone [phone]; fax [phone]; email [e-mail]; Internet http://www.bombardier.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. It is also available on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0333.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0333; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone [phone]) is Docket Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT:

Cesar Gomez, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone [phone]; fax [phone].

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Bombardier, Inc., Model CL-215-6B11 (CL-415 Variant) airplanes. The NPRM published in the Federal Register on May 9, 2017 (82 FR 21482).

Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian AD CF-2016-33, dated October 12, 2016 (referred to after this as the Mandatory Continuing Airworthiness Information, or “the MCAI”), to correct an unsafe condition for certain Bombardier, Inc., Model CL-215-6B11 (CL-415 Variant) airplanes. The MCAI states:

During the implementation of Service Bulletin (SB) 215-4051, the oxygen bottle was found loose while the clamp strap was in the locked position. This was determined to be caused by the quick release latch assembly not achieving the proper clamping pressure.

The release of the oxygen bottle due to improper clamping pressure may result in a loose mass cockpit hazard or an oxygen rich environment leading to a possible fire hazard.

In order to mitigate the unsafe condition, SB 215-4457 was issued to modify the clamp strap and install additional shims to add strength to the attaching structure for all affected aeroplanes.

You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0333.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Conclusion

We reviewed the relevant data and determined that air safety and the public interest require adopting this AD as proposed except for minor editorial changes. We have determined that these minor changes:

• Are consistent with the intent that was proposed in the NPRM for correcting the unsafe condition; and
• Do not add any additional burden upon the public than was already proposed in the NPRM.

Related Service Information Under 1 CFR Part 51

Bombardier, Inc., has issued Service Bulletin 215-4457, Revision 3, dated May 8, 2013. The service information describes procedures for installing shims, and, for certain airplanes, modifying the straps of the latch assembly, on the flight crew's oxygen bottles' retaining structure. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

Costs of Compliance

We estimate that this AD affects 24 airplanes of U.S. registry.

We estimate the following costs to comply with this AD:

Estimated Costs

Action	Labor cost	Parts cost	Cost per product	Cost on U.S. operators
Modification and installation	16 work-hours × $85 per hour = $1,360	$2,250	$3,610	$86,640

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);

3. Will not affect intrastate aviation in Alaska; and

4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

2017-15-14 Bombardier, Inc. (Type Certificate Previously Held by Canadair Limited): Amendment 39-18974; Docket No. FAA-2017-0333; Directorate Identifier 2017-NM-005-AD.

(a) Effective Date

This AD is effective September 5, 2017.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Bombardier, Inc. (Type Certificate previously held by Canadair Limited) Model CL-215-6B11 (CL-415 Variant) airplanes, certificated in any category, having serial numbers 2001, 2002, 2005 through 2007 inclusive, 2010, 2012 through 2017 inclusive, 2019, 2022 through 2024 inclusive, 2026, 2057, 2063, 2065, 2076, 2077, and 2081.

(d) Subject

Air Transport Association (ATA) of America Code 25, Equipment/Furnishings.

(e) Reason

This AD was prompted by a report indicating that an oxygen bottle was found loose while the clamp strap was in the locked position. We are issuing this AD to prevent an oxygen bottle from being released, which would result in a loose mass object in the cockpit and could also result in an oxygen-rich environment that could lead to a possible fire hazard.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Installation and Modification

Within 12 months after the effective date of this AD, install additional shims and modify the clamp strap, as applicable, to the flight crew's oxygen bottles' retaining structures, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 215-4457, Revision 3, dated May 8, 2013.

(h) Credit for Previous Actions

This paragraph provides credit for actions required by paragraph (g) of this AD, if those actions were performed before the effective date of this AD using any of the service information identified in paragraphs (h)(1), (h)(2), or (h)(3) of this AD.

(1) Bombardier Service Bulletin 215-4457, Revision 2, dated October 24, 2012.

(2) Bombardier Service Bulletin 215-4457, Revision 1, dated June 12, 2012.

(3) Bombardier Service Bulletin 215-4457, dated April 4, 2012.

(i) Other FAA AD Provisions

The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone [phone]; fax [phone]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, New York ACO, ANE-170, FAA; or Transport Canada Civil Aviation (TCCA); or Viking Air Limited's TCCA Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.

(j) Related Information

(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian AD CF-2016-33, dated October 12, 2016, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0333.

(2) For more information about this AD, contact Cesar Gomez, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone [phone]; fax [phone].

(3) Service information identified in this AD that is not incorporated by reference is available at the addresses specified in paragraphs (k)(3) and (k)(4) of this AD.

(k) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.

(i) Bombardier Service Bulletin 215-4457, Revision 3, dated May 8, 2013.

(ii) Reserved.

(3) For service information identified in this AD, contact Bombardier, Inc., 400 Côte-Vertu Road West, Dorval, Québec H4S 1Y9, Canada; telephone [phone]; fax [phone]; email [e-mail]; Internet http://www.bombardier.com.

(4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/​federal-register/​cfr/​ibr-locations.html.

Issued in Renton, Washington, on July 19, 2017.

Victor Wicklund,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.