2017-21882. Agency Information Collection Activities; Proposed Collection; Comment Request

AGENCY:

Federal Trade Commission (“FTC” or “Commission”).

ACTION:

Notice.

SUMMARY:

The information collection requirements described below will be submitted to the Office of Management and Budget (OMB) for review, as required by the Paperwork Reduction Act (PRA). The FTC seeks public comments on its proposal to extend, for three years, the current PRA clearance for information collection requirements contained in its Trade Regulation Rule entitled Labeling and Advertising of Home Insulation (R-value Rule or Rule). That clearance expires on January 31, 2018.

DATES:

Comments must be submitted by December 11, 2017.

ADDRESSES:

Interested parties may file a comment online or on paper by following the instructions in the Request for Comments part of the SUPPLEMENTARY INFORMATION section below. Write “R-value Rule: FTC File No. R811001” on your comment, and file your comment online at https://ftcpublic.commentworks.com/​ftc/​rvaluerulepra1 by following the instructions on the web-based form. If you prefer to file your comment on paper, mail your comment to the following address: Federal Trade Commission, Office of the Secretary, 600 Pennsylvania Avenue NW., Suite CC-5610 (Annex J), Washington, DC 20580, or deliver your comment to the following address: Federal Trade Commission, Office of the Secretary, Constitution Center, 400 7th Street SW., 5th Floor, Suite 5610 (Annex J), Washington, DC 20024.

FOR FURTHER INFORMATION CONTACT:

Requests for additional information should be addressed to Hampton Newsome, Attorney, Division of Enforcement, Bureau of Consumer Protection, Federal Trade Commission, Mail Code CC-9528, 600 Pennsylvania Ave. NW., Washington, DC 20580, [phone].

SUPPLEMENTARY INFORMATION:

Under the PRA, 44 U.S.C. 3501-3521, federal agencies must obtain approval from OMB for each collection of information they conduct or sponsor. “Collection of information” means agency requests or requirements that members of the public submit reports, keep records, or provide information to a third party. 44 U.S.C. 3502(3); 5 CFR 1320.3(c). As required by section 3506(c)(2)(A) of the PRA, the FTC is providing this opportunity for public comment before requesting that OMB extend the existing clearance for the information collection requirements contained in the Commission's R-value Rule, 16 CFR part 460 (OMB Control Number 3084-0109).

The FTC invites comments on: (1) Whether the proposed collection of information is necessary for the proper performance of the functions of the agency, including whether the information will have practical utility; (2) the accuracy of the agency's estimate of the burden of the proposed collection of information, including the validity of the methodology and assumptions used; (3) ways to enhance the quality, utility, and clarity of the information to be collected; and (4) ways to minimize the burden of the collection of information on those who are to respond, including through the use of appropriate automated, electronic, mechanical, or other technological collection techniques or other forms of information technology, e.g., permitting electronic submission of responses.

The R-value Rule establishes uniform standards for the substantiation and disclosure of accurate, material product information about the thermal performance characteristics of home insulation products. The R-value of an insulation signifies the insulation's degree of resistance to the flow of heat. This information tells consumers how well a product is likely to perform as an insulator and allows consumers to determine whether the cost of the insulation is justified.

R-Value Rule Burden Statement

Estimated annual hours burden: 131,740 hours.

The Rule's requirements include product testing, recordkeeping, and third-party disclosures on labels, fact sheets, advertisements, and other promotional materials. Based on information provided by members of the insulation industry, staff estimates that the Rule affects: (1) 150 insulation manufacturers and their testing laboratories; (2) 1,615 installers who sell home insulation; (3) 125,000 new home builders/sellers of site-built homes and approximately 5,500 dealers who sell manufactured housing; and (4) 25,000 retail sellers who sell home insulation for installation by consumers.

Under the Rule's testing requirements, manufacturers must test each insulation product for its R-value. Based on past industry input, staff estimates that the test takes approximately two hours. Approximately 15 of the 150 insulation manufacturers in existence introduce one new product each year. Their total annual testing burden is therefore approximately 30 hours.

Staff further estimates that most manufacturers require an average of approximately 20 hours per year regarding third-party disclosure requirements in advertising and other promotional materials. Only the five or six largest manufacturers require additional time, approximately 80 hours each. Thus, the annual third-party disclosure burden for manufacturers is approximately 3,360 hours [(144 manufacturers × 20 hours) + (6 manufacturers × 80 hours)].

While the Rule imposes recordkeeping requirements, most manufacturers and their testing laboratories keep their testing-related records in the ordinary course of business. Staff estimates that no more than one additional hour per year per manufacturer is necessary to comply with this requirement, for an annual recordkeeping burden of approximately 150 hours (150 manufacturers × 1 hour).

Installers are required to show the manufacturers' insulation fact sheet to retail consumers before purchase. They must also disclose information in contracts or receipts concerning the R-value and the amount of insulation to install. Staff estimates that two minutes per sales transaction is sufficient to comply with these requirements. Approximately 2,000,000 retrofit insulations (an industry source's estimate) are installed by approximately 1,615 installers per year, and, thus, the related annual burden total is approximately 66,667 hours (2,000,000 sales transactions × 2 minutes). Staff anticipates that one hour per year per installer is sufficient to cover required disclosures in advertisements and other promotional materials. Thus, the burden for this requirement is approximately 1,615 hours per year. In addition, installers must keep records that indicate the substantiation relied upon for savings claims. The additional time to comply with this requirement is minimal—approximately 5 minutes per year per installer—for a total of approximately 135 hours.

New home sellers must make contract disclosures concerning the type, thickness, and R-value of the insulation they install in each part of a new home. Staff estimates that no more than 30 seconds per sales transaction is required to comply with this requirement, for a total annual burden of approximately 9,783 hours (an estimated 1,174,000 new home sales per year ^[1] × 30 seconds). New home sellers who make energy savings claims must also keep records regarding the substantiation relied upon for those claims. Staff believes that the 30 seconds covering disclosures would also encompass this recordkeeping element.

The Rule requires that the approximately 25,000 retailers who sell home insulation make fact sheets available to consumers before purchase. This can be accomplished by, for example, placing copies in a display rack or keeping copies in a binder on a service desk with an appropriate notice. Replenishing or replacing fact sheets should require no more than approximately one hour per year per retailer, for a total of 25,000 annual hours, industry-wide.

The Rule also requires specific disclosures in advertisements or other promotional materials to ensure that the claims are fair and not deceptive. This burden is very minimal because retailers typically use advertising copy provided by the insulation manufacturer, and even when retailers prepare their own advertising copy, the Rule provides some of the language to be used. Accordingly, approximately one hour per year per retailer should suffice to meet this requirement, for a total annual burden of approximately 25,000 hours.

Retailers who make energy savings claims in advertisements or other promotional materials must keep records that indicate the substantiation they are relying upon. Because few retailers make these types of promotional claims and because the Rule permits retailers to rely on the insulation manufacturer's substantiation data for any claims that are made, the additional recordkeeping burden is de minimis. The time calculated for disclosures, above, would be more than adequate to cover any burden imposed by this recordkeeping requirement.

To summarize, staff estimates that the Rule imposes a total of 131,740 burden hours, as follows: 150 recordkeeping and 3,390 testing and disclosure hours for manufacturers; 135 recordkeeping and 68,282 disclosure hours for installers; 9,783 disclosure hours for new home sellers; and 50,000 disclosure hours for retailers. The estimated total burden is approximately 131,740 burden hours.

Estimated annual cost burden: $2,616,943 (solely related to labor costs).

The total annual labor cost for the Rule's information collection requirements is approximately $2,616,943, derived as follows: Approximately $858 for testing, based on 30 hours for manufacturers (30 hours × $28.61 per hour for skilled technical personnel); $4,284 for manufacturers' and installers' compliance with the Rule's recordkeeping requirements, based on 285 hours (285 hours × $15.03 per hour for clerical personnel); $50,501 for manufacturers' compliance with third-party disclosure requirements, based on 3,360 hours (3,360 hours × $15.03 per hour for clerical personnel); and $2,561,300 for disclosure compliance by installers, new home sellers, and retailers (128,065 hours × $20 per hour for sales persons).^[2]

There are no significant current capital or other non-labor costs associated with this Rule. Because the Rule has been in effect since 1980, members of the industry are familiar with its requirements and already have in place the equipment for conducting tests and storing records. New products are introduced infrequently. Because the required disclosures are placed on packaging or on the product itself, the Rule's additional disclosure requirements do not cause industry members to incur any significant additional non-labor associated costs.

Request for Comment

You can file a comment online or on paper. December 11, 2017. Write “R-value Rule: FTC File No. R811001” on your comment. Your comment—including your name and your state—will be placed on the public record of this proceeding, including, to the extent practicable, on the public Commission Web site, at https://www.ftc.gov/​policy/​public-comments. Postal mail addressed to the Commission is subject to delay due to heightened security screening. As a result, we encourage you to submit your comments online. To make sure that the Commission considers your online comment, you must file it at https://ftcpublic.commentworks.com/​ftc/​rvaluerulepra1 by following the instructions on the web based form. If this Notice appears at https://www.regulations.gov,, you also may file a comment through that Web site.

If you file your comment on paper, write “R-value Rule: FTC File No. R811001” on your comment and on the envelope, and mail your comment to the following address: Federal Trade Commission, Office of the Secretary, 600 Pennsylvania Avenue NW., Suite CC-5610 (Annex C), Washington, DC 20580, or deliver your comment to the following address: Federal Trade Commission, Office of the Secretary, Constitution Center, 400 7th Street SW., 5th Floor, Suite 5610, Washington, DC 20024. If possible, submit your paper comment to the Commission by courier or overnight service.

Because your comment will be placed on the publicly accessible FTC Web site at www.ftc.gov,, you are solely responsible for making sure that your comment does not include any sensitive or confidential information. In particular, your comment should not include any sensitive personal information, such as your or anyone else's Social Security number; date of birth; driver's license number or other state identification number, or foreign country equivalent; passport number; financial account number; or credit or debit card number. You are also solely responsible for making sure that your comment does not include any sensitive health information, such as medical records or other individually identifiable health information. In addition, your comment should not include any “trade secret or any commercial or financial information which . . . is privileged or confidential”—as provided by Section 6(f) of the FTC Act, 15 U.S.C. 46(f), and FTC Rule 4.10(a)(2), 16 CFR 4.10(a)(2)—including in particular competitively sensitive information such as costs, sales statistics, inventories, formulas, patterns, devices, manufacturing processes, or customer names.

Comments containing material for which confidential treatment is requested must be filed in paper form, must be clearly labeled “Confidential,” and must comply with FTC Rule 4.9(c). In particular, the written request for confidential treatment that accompanies the comment must include the factual and legal basis for the request, and must identify the specific portions of the comment to be withheld from the public record. See FTC Rule 4.9(c). Your comment will be kept confidential only if the General Counsel grants your request in accordance with the law and the public interest. Once your comment has been posted on the public FTC Web site—as legally required by FTC Rule 4.9(b)—we cannot redact or remove your comment from the FTC Web site, unless you submit a confidentiality request that meets the requirements for such treatment under FTC Rule 4.9(c), and the General Counsel grants that request.

Visit the Commission Web site at https://www.ftc.gov to read this Notice. The FTC Act and other laws that the Commission administers permit the collection of public comments to consider and use in this proceeding as appropriate. The Commission will consider all timely and responsive public comments that it receives on or before December 11, 2017. You can find more information, including routine uses permitted by the Privacy Act, in the Commission's privacy policy, at https://www.ftc.gov/​site-information/​privacy-policy.

David C. Shonka,

Acting General Counsel.

Footnotes

1.  See Table 3b on housing starts for privately owned units for 2016 at https://www.census.gov/​construction/​nrc/​pdf/​newresconst_​201706.pdf.

2.  The wage rates for engineering technicians, except drafters (skilled technical personnel), file clerks (clerical personnel), and sales and related occupations (sales persons) are based on recent data from the Bureau of Labor Statistics Occupational Employment Statistics Survey.