2010-13400. Airworthiness Directives; PILATUS Aircraft Ltd. Model PC-7 Airplanes  

  • Start Preamble Start Printed Page 32251

    AGENCY:

    Federal Aviation Administration (FAA), Department of Transportation (DOT).

    ACTION:

    Final Rule.

    SUMMARY:

    We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

    This Airworthiness Directive (AD) is prompted due to the discovery of corrosion at the bonding strap connections on the left and right lower longerons between fuselage frames 1 and 1A. The possibility of corrosion is increased because of the high electrical current flow between the tinned copper terminal lug of the bonding strap and the aluminum longeron.

    Such a condition, if left uncorrected, could lead to failure of the longeron and will prejudice the structural integrity of the aircraft.

    We are issuing this AD to require actions to correct the unsafe condition on these products.

    DATES:

    This AD becomes effective July 13, 2010.

    On July 13, 2010, the Director of the Federal Register approved the incorporation by reference of certain publications listed in this AD.

    ADDRESSES:

    You may examine the AD docket on the Internet at http://www.regulations.gov or in person at the Document Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Doug Rudolph, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4059; fax: (816) 329-4090.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on March 15, 2010 (75 FR 12150). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

    This Airworthiness Directive (AD) is prompted due to the discovery of corrosion at the bonding strap connections on the left and right lower longerons between fuselage frames 1 and 1A. The possibility of corrosion is increased because of the high electrical current flow between the tinned copper terminal lug of the bonding strap and the aluminum longeron.

    Such a condition, if left uncorrected, could lead to failure of the longeron and will prejudice the structural integrity of the aircraft.

    In order to correct and control the situation, this AD requires a one time inspection of the longeron structure and the terminal lugs of the bonding straps for signs of corrosion.

    For left and right lower longerons where corrosion is found during the inspection, the MCAI also requires repair of any longeron where corrosion is found.

    Comments

    We gave the public the opportunity to participate in developing this AD. We considered the comment received. The commenter supports the NPRM.

    Conclusion

    We reviewed the available data, including the comment received, and determined that air safety and the public interest require adopting the AD as proposed.

    Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

    We might also have required different actions in this AD from those in the MCAI in order to follow FAA policies. Any such differences are highlighted in a Note within the AD.

    Costs of Compliance

    We estimate that this AD will affect 10 products of U.S. registry. We also estimate that it will take about 4.5 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour.

    Based on these figures, we estimate the cost of this AD to the U.S. operators to be $3,825 or $383 per product.

    In addition, we estimate that any necessary follow-on actions will take about 3 work-hours and require parts costing $500, for a cost of $755 per product. We have no way of determining the number of products that may need these actions.

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

    We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.Start Printed Page 32252

    Regulatory Findings

    We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify this AD:

    (1) Is not a “significant regulatory action” under Executive Order 12866;

    (2) Is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

    (3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD Docket.

    Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov;​; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    Adoption of the Amendment

    Start Amendment Part

    Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

    End Amendment Part Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. The FAA amends § 39.13 by adding the following new AD:

    End Amendment Part

    2010-12-04 PILATUS Aircraft Ltd.: Amendment 39-16325; Docket No. FAA-2010-0250; Directorate Identifier 2010-CE-011-AD.

    Effective Date

    (a) This airworthiness directive (AD) becomes effective July 13, 2010.

    Affected ADs

    (b) None.

    Applicability

    (c) This AD applies to Model PC-7 airplanes, all serial numbers, certificated in any category.

    Subject

    (d) Air Transport Association of America (ATA) Code 53: Fuselage.

    Reason

    (e) The mandatory continuing airworthiness information (MCAI) states:

    This Airworthiness Directive (AD) is prompted due to the discovery of corrosion at the bonding strap connections on the left and right lower longerons between fuselage frames 1 and 1A. The possibility of corrosion is increased because of the high electrical current flow between the tinned copper terminal lug of the bonding strap and the aluminum longeron.

    Such a condition, if left uncorrected, could lead to failure of the longeron and will prejudice the structural integrity of the aircraft. In order to correct and control the situation, this AD requires a one time inspection of the longeron structure and the terminal lugs of the bonding straps for signs of corrosion.

    For left and right lower longerons where corrosion is found during the inspection, the MCAI also requires repair of any longeron where corrosion is found.

    Actions and Compliance

    (f) Unless already done, do the following actions:

    (1) Within the next 120 days after July 13, 2010 (the effective date of this AD), perform a visual inspection of the forward bonding points and the terminal lugs on the left and right lower longerons between fuselage frames 1 and 1A for signs of corrosion. Do the inspection following paragraphs 3.C.(1), (2), and (3) of PILATUS PC-7 Service Bulletin No. 53-007, dated January 5, 2010.

    (2) If any signs of corrosion are found during the inspection required in paragraph (f)(1) of this AD, prior to further flight, perform corrective actions in accordance with the Accomplishment Instructions in paragraph 3.D of PILATUS PC-7 SB No. 53-007, dated January 5, 2010. If the corrosion damage is out of limits, record the values; apply to PILATUS for a repair scheme at: PILATUS AIRCRAFT LTD., Customer Service Manager, CH-6371 STANS, Switzerland; telephone: +41 (0) 41 619 62 08; fax: +41 (0) 41 619 73 11; and implement the repair scheme.

    Note 1:

    The Federal Office of Civil Aviation (FOCA), which is the airworthiness authority for Switzerland, will work with PILATUS in reviewing the results of the initial inspection as specified in PILATUS PC-7 Service Bulletin No. 53-007, dated January 5, 2010. From this, a repetitive inspection requirement or other action may be established. The FAA will evaluate any such action and determine whether further rulemaking is necessary.

    FAA AD Differences

    Note 2:

    This AD differs from the MCAI and/or service information as follows: No differences.

    Other FAA AD Provisions

    (g) The following provisions also apply to this AD:

    (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to Attn: Doug Rudolph, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4059; fax: (816) 329-4090. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

    (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

    (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056.

    Related Information

    (h) Refer to MCAI FOCA AD HB-2010-001, dated February 12, 2010; and PILATUS PC-7 Service Bulletin No. 53-007, dated January 5, 2010, for related information.

    Material Incorporated by Reference

    (i) You must use PILATUS PC-7 Service Bulletin No. 53-007, dated January 5, 2010, to do the actions required by this AD, unless the AD specifies otherwise.

    (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51.

    (2) For service information identified in this AD, contact PILATUS AIRCRAFT LTD., Customer Service Manager, CH-6371 STANS, Switzerland; telephone: +41 (0) 41 619 62 08; fax: +41 (0) 41 619 73 11; Internet: http://www.pilatus-aircraft.com.

    (3) You may review copies of the service information incorporated by reference for this AD at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the Central Region, call (816) 329-3768.

    (4) You may also review copies of the service information incorporated by reference for this AD at the National Archives and Records Administration (NARA). For Start Printed Page 32253information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/​federal_​register/​code_​of_​federal_​regulations/​ibr_​locations.html.

    Start Signature

    Issued in Kansas City, Missouri, on May 27, 2010.

    Steven W. Thompson,

    Acting Manager, Small Airplane Directorate, Aircraft Certification Service.

    End Signature End Supplemental Information

    [FR Doc. 2010-13400 Filed 6-7-10; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Comments Received:
0 Comments
Effective Date:
7/13/2010
Published:
06/08/2010
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final Rule.
Document Number:
2010-13400
Dates:
This AD becomes effective July 13, 2010.
Pages:
32251-32253 (3 pages)
Docket Numbers:
Docket No. FAA-2010-0250 Directorate Identifier 2010-CE-011-AD, Amendment 39-16325, AD 2010-12-04
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
2010-13400.pdf
CFR: (1)
14 CFR 39.13