E8-17746. Airworthiness Directives; Dassault Model Falcon 2000EX Airplanes  

  • Start Preamble Start Printed Page 45345

    AGENCY:

    Federal Aviation Administration (FAA), Department of Transportation (DOT).

    ACTION:

    Final rule.

    SUMMARY:

    We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

    During approach, a Falcon 2000EX operator experienced a temporary loss of the 4 Electronic Flight Instrumentation System (EFIS) display units followed by a consecutive restart of the avionics. During initial investigation, a loose connection on the DC load distribution system was discovered and determined to be the root cause of this event. However, further analysis pointed out that large electrical transients on the essential bus bar may possibly cause simultaneous and temporary power shortage on both sides of the electrical system.

    This Airworthiness Directive (AD) * * * action is necessary to prevent a momentary loss of data on the EFIS screens, which could lead to the pilot's loss of situational awareness during initial climb or approach/landing, and possibly result in reduced control of the airplane. * * *

    We are issuing this AD to require actions to correct the unsafe condition on these products.

    DATES:

    This AD becomes effective September 9, 2008.

    The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of September 9, 2008.

    ADDRESSES:

    You may examine the AD docket on the Internet at http://www.regulations.gov or in person at the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on May 20, 2008 (73 FR 29091). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

    During approach, a Falcon 2000EX operator experienced a temporary loss of the 4 Electronic Flight Instrumentation System (EFIS) display units followed by a consecutive restart of the avionics. During initial investigation, a loose connection on the DC load distribution system was discovered and determined to be the root cause of this event. However, further analysis pointed out that large electrical transients on the essential bus bar may possibly cause simultaneous and temporary power shortage on both sides of the electrical system.

    This Airworthiness Directive (AD) requires a wiring modification of the GCUs (Generator Control Units) to increase the electrical system robustness. This action is necessary to prevent a momentary loss of data on the EFIS screens, which could lead to the pilot's loss of situational awareness during initial climb or approach/landing, and possibly result in reduced control of the airplane. This action is intended to address the identified unsafe condition.

    You may obtain further information by examining the MCAI in the AD docket.

    Comments

    We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

    Conclusion

    We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

    Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

    We might also have required different actions in this AD from those in the MCAI in order to follow our FAA policies. Any such differences are highlighted in a Note within the AD.

    Costs of Compliance

    We estimate that this AD will affect about 57 products of U.S. registry. We also estimate that it will take about 8 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $80 per work-hour. Required parts will cost about $0 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $36,480, or $640 per product.

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

    We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    Regulatory Findings

    We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify this AD:

    1. Is not a “significant regulatory action” under Executive Order 12866;

    2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

    3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities Start Printed Page 45346under the criteria of the Regulatory Flexibility Act.

    We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

    Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    Adoption of the Amendment

    Start Amendment Part

    Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

    End Amendment Part Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. The FAA amends § 39.13 by adding the following new AD:

    End Amendment Part

    2008-16-08 Dassault Aviation: Amendment 39-15626. Docket No. FAA-2008-0557; Directorate Identifier 2007-NM-364-AD.

    Effective Date

    (a) This airworthiness directive (AD) becomes effective September 9, 2008.

    Affected ADs

    (b) None.

    Applicability

    (c) This AD applies to Dassault Model Falcon 2000EX airplanes from serial number 1 to 107 inclusive, certificated in any category; which have not been modified by Dassault Service Bulletin (SB) F2000EX-141.

    Subject

    (d) Air Transport Association (ATA) of America Code 24: Electrical Power.

    Reason

    (e) The mandatory continuing airworthiness information (MCAI) states:

    During approach, a Falcon 2000EX operator experienced a temporary loss of the 4 Electronic Flight Instrumentation System (EFIS) display units followed by a consecutive restart of the avionics. During initial investigation, a loose connection on the DC load distribution system was discovered and determined to be the root cause of this event. However, further analysis pointed out that large electrical transients on the essential bus bar may possibly cause simultaneous and temporary power shortage on both sides of the electrical system.

    This Airworthiness Directive (AD) requires a wiring modification of the GCUs (Generator Control Units) to increase the electrical system robustness. This action is necessary to prevent a momentary loss of data on the EFIS screens, which could lead to the pilot's loss of situational awareness during initial climb or approach/landing, and possibly result in reduced control of the airplane. This action is intended to address the identified unsafe condition.

    Actions and Compliance

    (f) Unless already done, do the following actions.

    (1) Within 13 months after the effective date of this AD, modify the GCU electrical wiring as instructed in the Accomplishment Instructions of Dassault Service Bulletin F2000EX-141, Revision 1, dated November 26, 2007.

    (2) Actions done prior to the effective date of this AD according to Dassault Service Bulletin F2000EX-141, dated February 16, 2007, are acceptable for compliance with the corresponding requirements of this AD.

    FAA AD Differences

    Note:

    This AD differs from the MCAI and/or service information as follows: No differences.

    Other FAA AD Provisions

    (g) The following provisions also apply to this AD:

    (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

    (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

    (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056.

    Related Information

    (h) Refer to MCAI European Aviation Safety Agency Airworthiness Directive 2007-0290, dated November 26, 2007; and Dassault Service Bulletin F2000EX-141, Revision 1, dated November 26, 2007; for related information.

    Material Incorporated by Reference

    (i) You must use Dassault Service Bulletin F2000EX-141, Revision 1, dated November 26, 2007, to do the actions required by this AD, unless the AD specifies otherwise.

    (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51.

    (2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606.

    (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/​federal-register/​cfr/​ibr-locations.html.

    Start Signature

    Issued in Renton, Washington, on July 23, 2008.

    Ali Bahrami,

    Manager, Transport Airplane Directorate, Aircraft Certification Service.

    End Signature End Supplemental Information

    [FR Doc. E8-17746 Filed 8-4-08; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Comments Received:
0 Comments
Effective Date:
9/9/2008
Published:
08/05/2008
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final rule.
Document Number:
E8-17746
Dates:
This AD becomes effective September 9, 2008.
Pages:
45345-45346 (2 pages)
Docket Numbers:
Docket No. FAA-2008-0557, Directorate Identifier 2007-NM-364-AD, Amendment 39-15626, AD 2008-16-08
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
e8-17746.pdf
CFR: (1)
14 CFR 39.13