eLaws | eCases | United States Code | Federal Courts |
 Code of Federal Regulations (Last Updated: November 8, 2024)
 Title 40 - Protection of Environment
 Chapter I - Environmental Protection Agency
 SubChapter C - Air Programs
 Part 60 - Standards of Performance for New Stationary Sources
 Subpart EEEE - Standards of Performance for Other Solid Waste Incineration Units for Which Construction is Commenced After December 9, 2004, or for Which Modification or Reconstruction is Commenced on or After June 16, 2006

  Table 1 to Subpart EEEE of Part 60 - Emission Limitations  

Latest version.

  • Table 1 to Subpart EEEE of Part 60 - Emission Limitations

    As stated in § 60.2915, you must comply with the following:

    For the air pollutant You must meet this emission
    limitationa     		Using this averaging time And determining
    compliance using this method
    1. Cadmium 18 micrograms per dry standard cubic meter 3-run average (1 hour minimum sample time per run) Method 29 of appendix A of this part.
    2. Carbon monoxide 40 parts per million by dry volume 3-run average (1 hour minimum sample time per run during performance test), and 12-hour rolling averages measured using CEMS.b Method 10, 10A, or 10B of appendix A of this part and CEMS.
    3. Dioxins/furans (total basis) 33 nanograms per dry standard cubic meter 3-run average (1 hour minimum sample meter time per run) Method 23 of appendix A of this part.
    4. Hydrogen chloride 15 parts per million by dry volume 3-run average (1 hour minimum sample time per run) Method 26A of appendix A of this part.
    5. Lead 226 micrograms per dry standard cubic meter 3-run average (1 hour minimum sample time per run) Method 29 of appendix A of this part.
    6. Mercury 74 micrograms per dry standard cubic meter 3-run average (1 hour minimum sample time per run) Method 29 of appendix A of this part.
    7. Opacity 10 percent 6-minute average (observe over three 1-hour test runs; i.e., thirty 6-minute averages) Method 9 of appendix A of this part.
    8. Oxides of nitrogen 103 parts per million by dry volume 3-run average (1 hour minimum sample time per run) Method 7, 7A, 7C, 7D, or 7E of appendix A of this part, or ANSI/ASME PTC 19.10-1981 (IBR, see § 60.17(h)) in lieu of Methods 7 and 7C only.
    9. Particulate matter 0.013 grains per dry standard cubic foot 3-run average (1 hour minimum sample time per run) Method 5 or 29 of appendix A of this part.
    10. Sulfur dioxide 3.1 parts per million by dry volume 3-run average (1 hour minimum sample time per run) Method 6 or 6C of appendix A of this part, or ANSI/ASME PTC 19.10-1981 (IBR, see § 60.17(h)) in lieu of Method 6 only.

    a All emission limitations (except for opacity) are measured at 7 percent oxygen, dry basis at standard conditions.

    b Calculated each hour as the average of the previous 12 operating hours.