§ 63.7733 - What procedures must I use to establish operating limits?  


Latest version.
  • § 63.7733 What procedures must I use to establish operating limits?

    (a) For each capture system subject to operating limits in § 63.7690(b)(1)(ii), you must establish site-specific operating limits in your operation and maintenance plan according to the procedures in paragraphs (a)(1) through (3) of this section.

    (1) Concurrent with applicable emissions and opacity tests, measure and record values for each of the operating limit parameters in your capture system operation and maintenance plan according to the monitoring requirements in § 63.7740(a).

    (2) For any dampers that are manually set and remain at the same position at all times the capture system is operating, the damper position must be visually checked and recorded at the beginning and end of each run.

    (3) Review and record the monitoring data. Identify and explain any times the capture system operated outside the applicable operating limits.

    (b) For each wet scrubber subject to the operating limits in § 63.7690(b)(2) for pressure drop and scrubber water flow rate, you must establish site-specific operating limits according to the procedures specified in paragraphs (b)(1) and (2) of this section.

    (1) Using the CPMS required in § 63.7740(c), measure and record the pressure drop and scrubber water flow rate in intervals of no more than 15 minutes during each PM test run.

    (2) Compute and record the average pressure drop and average scrubber water flow rate for each valid sampling run in which the applicable emissions limit is met.

    (c) For each combustion device applied to emissions from a scrap preheater or TEA cold box mold or core making line subject to the operating limit in § 63.7690(b)(4) for combustion zone temperature, you must establish a site-specific operating limit according to the procedures specified in paragraphs (c)(1) and (2) of this section.

    (1) Using the CPMS required in § 63.7740(e), measure and record the combustion zone temperature during each sampling run in intervals of no more than 15 minutes.

    (2) Compute and record the average combustion zone temperature for each valid sampling run in which the applicable emissions limit is met.

    (d) For each acid wet scrubber subject to the operating limit in § 63.7690(b)(5), you must establish a site-specific operating limit for scrubbing liquid flow rate according to the procedures specified in paragraphs (d)(1) and (2) of this section.

    (1) Using the CPMS required in § 63.7740(f), measure and record the scrubbing liquid flow rate during each TEA sampling run in intervals of no more than 15 minutes.

    (2) Compute and record the average scrubbing liquid flow rate for each valid sampling run in which the applicable emissions limit is met.

    (e) You may change the operating limits for a capture system, wet scrubber, acid wet scrubber, or combustion device if you meet the requirements in paragraphs (e)(1) through (3) of this section.

    (1) Submit a written notification to the Administrator of your request to conduct a new performance test to revise the operating limit.

    (2) Conduct a performance test to demonstrate compliance with the applicable emissions limitation in § 63.7690.

    (3) Establish revised operating limits according to the applicable procedures in paragraphs (a) through (d) of this section.

    (f) You may use a previous performance test (conducted since December 22, 2002) to establish an operating limit provided the test meets the requirements of this subpart.

    [69 FR 21923, Apr. 22, 2004, as amended at 73 FR 7221, Feb. 7, 2008]