[Federal Register Volume 63, Number 204 (Thursday, October 22, 1998)]
[Rules and Regulations]
[Pages 56544-56545]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-28157]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 98-NM-188-AD; Amendment 39-10849; AD 98-22-03]
RIN 2120-AA64
Airworthiness Directives; Saab Model SAAB SF340A and SAAB 340B
Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD),
applicable to certain Saab Model SAAB SF340A and SAAB 340B series
airplanes, that requires a one-time visual inspection of the main
landing gear (MLG) brake assemblies to determine the brake
configuration, and reconfiguration, if necessary. This amendment is
prompted by issuance of mandatory continuing airworthiness information
by a foreign civil airworthiness authority. The actions specified by
this AD are intended to prevent an incorrect brake combination
configuration of the MLG, and consequent reduced controllability of the
airplane during take-off and landing.
DATES: Effective November 27, 1998.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of November 27, 1998.
ADDRESSES: The service information referenced in this AD may be
obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-
581.88, Linkoping, Sweden. This information may be examined at the
Federal Aviation Administration (FAA), Transport Airplane Directorate,
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the
Office of the Federal Register, 800 North Capitol Street, NW., suite
700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager,
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)
227-2110; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an airworthiness
directive (AD) that is applicable to certain Saab Model SAAB SF340A and
SAAB 340B series airplanes was published in the Federal Register on
August 26, 1998 (63 FR 45425). That action proposed to require a one-
time visual inspection of the main landing gear (MLG) brake assemblies
to determine the brake configuration, and reconfiguration, if
necessary.
Comments
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were submitted in response
to the proposal or the FAA's determination of the cost to the public.
Conclusion
The FAA has determined that air safety and the public interest
require the adoption of the rule as proposed.
Cost Impact
The FAA estimates that 276 airplanes of U.S. registry will be
affected by this AD, that it will take approximately 1 work hour per
airplane to accomplish the required inspection, and that the average
labor rate is $60 per work hour. Based on these figures, the cost
impact of the inspection required by this AD on U.S. operators is
estimated to be $16,560, or $60 per airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the requirements of this AD
action, and that no operator would accomplish those actions in the
future if this AD were not adopted.
Regulatory Impact
The regulations adopted herein will not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this final
rule does not have sufficient federalism implications to warrant the
preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules Docket at the location provided under the caption
ADDRESSES.
[[Page 56545]]
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
98-22-03 Saab Aircraft AB: Amendment 39-10849. Docket 98-NM-188-AD.
Applicability: Model SAAB SF340A series airplanes having serial
numbers (S/N) -004 through -159 inclusive, and SAAB 340B series
airplanes having S/N's -160 through -439 inclusive; on which SAAB
Modification 2898 (reference SAAB Service Bulletin 340-32-113, dated
November 14, 1997, or Revision 1, dated February 9, 1998) has been
accomplished; certificated in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
otherwise modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (b) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To prevent an incorrect brake combination of the main landing
gear (MLG), and consequent reduced controllability of the airplane
during take-off and landing, accomplish the following:
(a) Within 2 months after the effective date of this AD, perform
a one-time visual inspection of the MLG brake assemblies to
determine the brake configuration, in accordance with Saab Service
Bulletin 340-32-114, dated May 4, 1998.
(1) If the configuration of the brake assemblies is specified in
Table 1 of the service bulletin as permissible combinations, no
further action is required by this AD.
(2) If the configuration of the brake assemblies is not
specified in Table 1 of the service bulletin as a permissible
combination, prior to further flight, reconfigure the brake
assemblies, in accordance with the service bulletin.
(b) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, International Branch, ANM-116, FAA,
Transport Airplane Directorate. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager, International
Branch, ANM-116.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the International Branch, ANM-116.
(c) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
(d) The actions shall be done in accordance with SAAB Service
Bulletin 340-32-114, dated May 4, 1998. This incorporation by
reference was approved by the Director of the Federal Register in
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be
obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-
581.88, Linkoping, Sweden. Copies may be inspected at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington; or at the Office of the Federal Register, 800 North
Capitol Street, NW., suite 700, Washington, DC.
Note 3: The subject of this AD is addressed in Swedish
airworthiness directive 1-127, dated May 5, 1998.
(e) This amendment becomes effective on November 27, 1998.
Issued in Renton, Washington, on October 14, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 98-28157 Filed 10-21-98; 8:45 am]
BILLING CODE 4910-13-U
