97-28576. Airworthiness Directives; Industrie Aeronautiche e Meccaniche Rinaldo Piaggio S.p.A. Model P-180 Airplanes  

  • [Federal Register Volume 62, Number 209 (Wednesday, October 29, 1997)]
    [Rules and Regulations]
    [Pages 56061-56062]
    From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
    [FR Doc No: 97-28576]
    
    
    -----------------------------------------------------------------------
    
    DEPARTMENT OF TRANSPORTATION
    
    Federal Aviation Administration
    
    14 CFR Part 39
    
    [Docket No. 97-CE-25-AD; Amendment 39-10183; AD 97-22-11]
    RIN 2120-AA64
    
    
    Airworthiness Directives; Industrie Aeronautiche e Meccaniche 
    Rinaldo Piaggio S.p.A. Model P-180 Airplanes
    
    AGENCY: Federal Aviation Administration, DOT.
    
    ACTION: Final rule.
    
    -----------------------------------------------------------------------
    
    SUMMARY: This amendment adopts a new airworthiness directive (AD) that 
    applies to all Industrie Aeronautiche e Meccaniche Rinaldo Piaggio 
    S.p.A. (Piaggio) Model P-180 airplanes. This AD requires amending the 
    Limitations Section of the airplane flight manual (AFM) to prohibit the 
    positioning of the power levers below the flight idle stop while the 
    airplane is in flight. This AFM amendment will include a statement of 
    consequences if the limitation is not followed. This AD results from 
    numerous incidents and five documented accidents involving airplanes 
    equipped with turboprop engines where the propeller beta was improperly 
    utilized during flight. The actions specified by this AD are intended 
    to prevent loss of airplane control or engine overspeed with consequent 
    loss of engine power caused by the power levers being positioned below 
    the flight idle stop while the airplane is in flight.
    
    EFFECTIVE DATE: December 5, 1997.
    
    ADDRESSES: Information related to this AD may be examined at the 
    Federal Aviation Administration (FAA), Central Region, Office of the 
    Regional Counsel, Attention: Rules Docket 97-CE-25-AD, Room 1558, 601 
    E. 12th Street, Kansas City, Missouri 64106.
    
    FOR FURTHER INFORMATION CONTACT: J. Mike Kiesov, Aerospace Engineer, 
    Small Airplane Directorate, FAA, 1201 Walnut, suite 900, Kansas City, 
    Missouri 64106; telephone (816) 426-6934; facsimile (816) 426-2169.
    
    SUPPLEMENTARY INFORMATION:
    
    Events Leading to the Issuance of This AD
    
        A proposal to amend part 39 of the Federal Aviation Regulations (14 
    CFR part 39) to include an AD that would apply to all Piaggio Model P-
    180 airplanes was published in the Federal Register as a notice of 
    proposed rulemaking (NPRM) on July 2, 1997 (62 FR 35698).
        The NPRM proposed to require amending the Limitations Section of 
    the AFM to prohibit the positioning of the power levers below the 
    flight idle stop while the airplane is in flight, including a statement 
    of consequences if the limitation is not followed. This AFM amendment 
    shall consist of the following language:
    
        Positioning of power levers below the flight idle stop while the 
    airplane is in flight is prohibited. Such positioning may lead to 
    loss of airplane control or may result in an overspeed condition and 
    consequent loss of engine power.
    
        The NPRM is the result of numerous incidents and five documented 
    accidents involving airplanes equipped with turboprop engines where the 
    propeller beta was improperly utilized during flight.
        Interested persons have been afforded an opportunity to participate 
    in the making of this amendment. No comments were received on the 
    proposed rule or the FAA's determination of the cost to the public.
    
    The FAA's Determination
    
        After careful review of all available information related to the 
    subject presented above, the FAA has determined that air safety and the 
    public interest require the adoption of the rule as proposed except for 
    minor editorial corrections. The FAA has determined that these minor 
    corrections will not change the meaning of the AD and will not add any 
    additional burden upon the public than was already proposed.
    
    Compliance Time of This AD
    
        The FAA has determined that the compliance time of this AD should 
    be specified in calendar time instead of hours time-in-service. While 
    the condition addressed by this AD is unsafe while the airplane is in 
    flight, the condition is not a result of repetitive airplane operation; 
    the potential of the unsafe condition occurring is the same on the 
    first flight as it is for subsequent flights. The compliance time of 
    ``30 days after the effective date of this AD'' will not inadvertently 
    ground airplanes and would assure that all owners/operators of the 
    affected airplanes accomplish this AD in a reasonable time period.
    
    Cost Impact
    
        The FAA estimates that 4 airplanes in the U.S. registry will be 
    affected by this AD, that it will take approximately 1 workhour per 
    airplane to incorporate the required AFM amendment, and that the 
    average labor rate is approximately $60 an hour. Since an owner/
    operator who holds at least a private pilot's
    
    [[Page 56062]]
    
    certificate as authorized by Secs. 43.7 and 43.11 of the Federal 
    Aviation Regulations (14 CFR 43.7 and 43.11) can accomplish this AD, 
    the only cost impact upon the public is the time it will take the 
    affected airplane owner/operators to amend the AFM.
    
    Regulatory Impact
    
        The regulations adopted herein will not have substantial direct 
    effects on the States, on the relationship between the national 
    government and the States, or on the distribution of power and 
    responsibilities among the various levels of government. Therefore, in 
    accordance with Executive Order 12612, it is determined that this final 
    rule does not have sufficient federalism implications to warrant the 
    preparation of a Federalism Assessment.
        For the reasons discussed above, I certify that this action (1) is 
    not a ``significant regulatory action'' under Executive Order 12866; 
    (2) is not a ``significant rule'' under DOT Regulatory Policies and 
    Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
    significant economic impact, positive or negative, on a substantial 
    number of small entities under the criteria of the Regulatory 
    Flexibility Act. A copy of the final evaluation prepared for this 
    action is contained in the Rules Docket. A copy of it may be obtained 
    by contacting the Rules Docket at the location provided under the 
    caption ADDRESSES.
    
    List of Subjects in 14 CFR Part 39
    
        Air transportation, Aircraft, Aviation safety, Safety.
    
    Adoption of the Amendment
    
        Accordingly, pursuant to the authority delegated to me by the 
    Administrator, the Federal Aviation Administration amends part 39 of 
    the Federal Aviation Regulations (14 CFR part 39) as follows:
    
    PART 39--AIRWORTHINESS DIRECTIVES
    
        1. The authority citation for part 39 continues to read as follows:
    
        Authority: 49 USC 106(g), 40113, 44701.
    
    
    Sec. 39.13  [Amended]
    
        2. Section 39.13 is amended by adding a new airworthiness directive 
    (AD) to read as follows:
    
    97-22-11  Industrie Aeronautiche E Meccaniche Rinaldo Piaggio S.P.A: 
    Amendment 39-10183; Docket No. 97-CE-25-AD.
        Applicability: Model P-180 airplanes, all serial numbers, 
    certificated in any category.
    
        Note 1: This AD applies to each airplane identified in the 
    preceding applicability provision, regardless of whether it has been 
    modified, altered, or repaired in the area subject to the 
    requirements of this AD. For airplanes that have been modified, 
    altered, or repaired so that the performance of the requirements of 
    this AD is affected, the owner/operator must request approval for an 
    alternative method of compliance in accordance with paragraph (e) of 
    this AD. The request should include an assessment of the effect of 
    the modification, alteration, or repair on the unsafe condition 
    addressed by this AD; and, if the unsafe condition has not been 
    eliminated, the request should include specific proposed actions to 
    address it.
    
        Compliance: Required within the next 30 days after the effective 
    date of this AD, unless already accomplished.
        To prevent loss of airplane control or engine overspeed with 
    consequent loss of engine power caused by the power levers being 
    positioned below the flight idle stop while the airplane is in 
    flight, accomplish the following:
        (a) Amend the Limitations Section of the airplane flight manual 
    (AFM) by inserting the following language:
        Positioning of power levers below the flight idle stop while the 
    airplane is in flight is prohibited. Such positioning may lead to 
    loss of airplane control or may result in an overspeed condition and 
    consequent loss of engine power.
        (b) This action may be accomplished by incorporating a copy of 
    this AD into the Limitations Section of the AFM.
        (c) Amending the AFM, as required by this AD, may be performed 
    by the owner/operator holding at least a private pilot certificate 
    as authorized by section 43.7 of the Federal Aviation Regulations 
    (14 CFR 43.7), and must be entered into the aircraft records showing 
    compliance with this AD in accordance with section 43.11 of the 
    Federal Aviation Regulations (14 CFR 43.11).
        (d) Special flight permits may be issued in accordance with 
    sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
    CFR 21.197 and 21.199) to operate the airplane to a location where 
    the requirements of this AD can be accomplished.
        (e) An alternative method of compliance or adjustment of the 
    compliance time that provides an equivalent level of safety may be 
    approved by the Manager, Small Airplane Directorate, FAA, 1201 
    Walnut, suite 900, Kansas City, Missouri 64106. The request shall be 
    forwarded through an appropriate FAA Maintenance Inspector, who may 
    add comments and then send it to the Manager, Small Airplane 
    Directorate.
    
        Note 2: Information concerning the existence of approved 
    alternative methods of compliance with this AD, if any, may be 
    obtained from the Small Airplane Directorate.
    
        (f) Information related to this AD may be examined at the FAA, 
    Central Region, Office of the Regional Counsel, Room 1558, 601 E. 
    12th Street, Kansas City, Missouri 64106.
        (g) This amendment (39-10183) becomes effective on December 5, 
    1997.
    
        Issued in Kansas City, Missouri, on October 21, 1997.
    Mary Ellen A. Schutt,
    Acting Manager, Small Airplane Directorate, Aircraft Certification 
    Service.
    [FR Doc. 97-28576 Filed 10-28-97; 8:45 am]
    BILLING CODE 4910-13-U
    
    
    

Document Information

Effective Date:
12/5/1997
Published:
10/29/1997
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final rule.
Document Number:
97-28576
Dates:
December 5, 1997.
Pages:
56061-56062 (2 pages)
Docket Numbers:
Docket No. 97-CE-25-AD, Amendment 39-10183, AD 97-22-11
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
PDF File:
97-28576.pdf
CFR: (1)
14 CFR 39.13