[Federal Register Volume 61, Number 216 (Wednesday, November 6, 1996)]
[Rules and Regulations]
[Pages 57295-57296]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 96-26953]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
14 CFR Part 39
[Docket No. 95-NM-167-AD; Amendment 39-9792; AD 96-22-03]
RIN 2120-AA64
Airworthiness Directives; Beech (Raytheon) Model BAe 125 Series
1000A and Model Hawker 1000 Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD),
applicable to certain Beech (Raytheon) Model BAe series 1000A and Model
Hawker 1000 airplanes, that requires modifications of the thrust
reversers. This amendment is prompted by a review of the certification
analysis of the thrust reversers and by testing of the thrust
reversers, which indicated that additional design features are
necessary to prevent failure of the driver link and the inadvertent
deployment of a thrust reverser during flight. The actions specified by
this AD are intended to prevent inadvertent deployment of a thrust
reverser during flight, which could result in reduced controllability
of the airplane.
DATES: Effective December 11, 1996.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of December 11, 1996.
ADDRESSES: The service information referenced in this AD may be
obtained from Raytheon Aircraft Company, Manager Service Engineering,
Hawker Customer Support Department, P.O. Box 85, Wichita, Kansas 67201-
0085. This information may be examined at the Federal Aviation
Administration (FAA), Transport Airplane Directorate, Rules Docket,
1601 Lind Avenue, SW., Renton, Washington; or at the Office of the
Federal Register, 800 North Capitol Street, NW., suite 700, Washington,
DC.
FOR FURTHER INFORMATION CONTACT: Tim Backman, Aerospace Engineer,
Standardization Branch, ANM-113, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206)
227-2797; fax (206) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an airworthiness
directive (AD) that is applicable to certain Beech (Raytheon) Model BAe
series 1000A and Model Hawker 1000 airplanes was published in the
Federal Register on August 9, 1996 (61 FR 41537). That action proposed
to require modifications of the thrust reversers.
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were submitted in response
to the proposal or the FAA's determination of the cost to the public.
Conclusion
The FAA has determined that air safety and the public interest
require the adoption of the rule as proposed.
Cost Impact
The FAA estimates that 23 Beech (Raytheon) Model BAe series 100A
and Model Hawker 1000 airplanes of U.S. registry will be affected by
this AD, that it will take approximately 110 work hours per airplane
(excluding time to gain access and functional testing) to accomplish
the required actions, and that the average labor rate is $60 per work
hour. Required parts will be provided by the manufacturer at no cost to
operators. Based on these figures, the cost impact of the AD on U.S.
operators is estimated to be $151,800, or $6,600 per airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the requirements of this AD
action, and that no operator would accomplish those actions in the
future if this AD were not adopted.
[[Page 57296]]
Regulatory Impact
The regulations adopted herein will not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this final
rule does not have sufficient federalism implications to warrant the
preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules Docket at the location provided under the caption
ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
96-22-03 Beech Aircraft Corporation (Formerly deHavilland; Hawker
Siddeley; British Aerospace, plc; Raytheon Corporate Jets, Inc.):
Amendment 39-9792. Docket 95-NM-167-AD.
Applicability: Model BAe series 1000A and Model Hawker 1000
airplanes; as identified in Hawker Service Bulletin SB.78-14-3691A,
B&E, dated June 21, 1995; certificated in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
otherwise modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (b) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Note 2: Beech (Raytheon) Model BAe 125 series 1000B airplanes
are similar in design to the airplanes that are subject to the
requirements of this AD and, therefore, also may be subject to the
unsafe condition addressed by this AD. However, as of the effective
date of this AD, those models are not type certificated for
operation in the United States. Airworthiness authorities of
countries in which the Model BAe 125 series 1000B airplanes are
approved for operation should consider adopting corrective action,
applicable to those models, that is similar to the corrective action
required by this AD.
Compliance: Required as indicated, unless accomplished
previously.
To prevent inadvertent deployment of a thrust reverser during
flight, and consequent reduced controllability of the airplane,
accomplish the following:
(a) Within 6 months after the effective date of this AD, modify
the thrust reversers by accomplishing Modifications 253691 Part A,
Part B, and Part E, in accordance with Hawker Service Bulletin
SB.78-14-3691A, B&E, dated June 21, 1995.
Note 3: The Hawker service bulletin references Rohr Service
Bulletin PW300 78-8, dated June 21, 1995, as an additional source of
service information for accomplishment of Modification 253691 Part
E.
(b) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, Standardization Branch, ANM-113,
FAA, Transport Airplane Directorate. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager,
Standardization Branch, ANM-113.
Note 4: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the Standardization Branch, ANM-113.
(c) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
(d) The modifications shall be done in accordance with Hawker
Service Bulletin SB.78-14-3691 A,B&E, dated June 21, 1995. This
incorporation by reference was approved by the Director of the
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part
51. Copies may be obtained from Raytheon Aircraft Company, Manager
Service Engineering, Hawker Customer Support Department, P.O. Box
85, Wichita, Kansas 67201-0085. Copies may be inspected at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington; or at the Office of the Federal Register, 800 North
Capitol Street, NW., suite 700, Washington, DC.
(e) This amendment becomes effective on December 11, 1996.
Issued in Renton, Washington, on October 15, 1996.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 96-26953 Filed 11-5-96; 8:45 am]
BILLING CODE 4910-13-U
