04-5430. Airworthiness Directives; Boeing Model 777 Series Airplanes

AGENCY:

Federal Aviation Administration, DOT.

ACTION:

Final rule.

SUMMARY:

This amendment adopts a new airworthiness directive (AD), applicable to certain Boeing Model 777 series airplanes, that requires replacement of the cargo control joysticks with new joysticks that include a moisture seal and ventilated cover. This action is necessary to prevent water from being trapped inside the joystick covers, which could result in uncommanded movements of the power drive unit during ground handling of cargo and consequent possible injury to ground personnel. This action is intended to address the identified unsafe condition.

DATES:

Effective April 19, 2004.

The incorporation by reference of a certain publication listed in the regulations is approved by the Director of the Federal Register as of April 19, 2004.

ADDRESSES:

The service information referenced in this AD may be obtained from Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT:

Clint Jones, Aerospace Engineer, Cabin Safety and Environmental Systems Branch, ANM-150S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone [phone]; fax [phone].

SUPPLEMENTARY INFORMATION:

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Boeing Model 777 series airplanes was published in the Federal Register on November 28, 2003 (68 FR 66764). That action proposed to require replacement of the cargo control joysticks with new joysticks that include a moisture seal and ventilated cover.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. Due consideration has been given to the comments received.

Support for Proposed AD

One commenter concurs with the proposed AD.

Request To Correct Date of Referenced Service Information

One commenter requests that the proposed AD be revised to reference the correct issue date for Boeing Service Bulletin 777-25-0191. The commenter points out that the correct issue date of that document is September 13, 2001. The FAA agrees and has revised this final rule to correct the typographical error.

Conclusion

After careful review of the available data, including the comments noted above, the FAA has determined that air safety and the public interest require the adoption of the rule with the change previously described. The FAA has determined that this change will neither increase the economic burden on any operator nor increase the scope of the AD.

Cost Impact

There are approximately 360 airplanes of the affected design in the worldwide fleet. The FAA estimates that 124 airplanes of U.S. registry will be affected by this AD, that it will take approximately 3 work hours per airplane to accomplish the required replacement, and that the average labor rate is $65 per work hour. Required parts will cost approximately $2,200 per airplane. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $296,980, or $2,395 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions. The manufacturer may cover the cost of replacement parts associated with this AD, subject to warranty conditions. Manufacturer warranty remedies may also be available for labor costs associated with this AD. As a result, the costs attributable to the AD may be less than stated above.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

2004-05-26  Boeing: Amendment 39-13521. Docket 2002-NM-14-AD.

Applicability: Model 777 series airplanes, as listed in Boeing Service Bulletin 777-25-0191, dated September 13, 2001; certificated in any category.

Compliance: Required as indicated, unless accomplished previously.

To prevent uncommanded movements of the power drive unit during ground handling of cargo and consequent possible injury to ground personnel, accomplish the following:

Replacement

(a) Within 18 months after the effective date of this AD, replace the cargo control joysticks with new joysticks, per the Accomplishment Instructions of Boeing Service Bulletin 777-25-0191, dated September 13, 2001.

Parts Installation

(b) As of the effective date of this AD, no person shall install a cargo control joystick, part number S283W602-1 or S283W602-2, on any airplane.

Alternative Methods of Compliance

(c) In accordance with 14 CFR 39.19, the Manager, Seattle Aircraft Certification Office, FAA, is authorized to approve alternative methods of compliance for this AD.

Incorporation by Reference

(d) The actions shall be done in accordance with Boeing Service Bulletin 777-25-0191, dated September 13, 2001. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Effective Date

(e) This amendment becomes effective on April 19, 2004.

Issued in Renton, Washington, on March 3, 2004.

Ali Bahrami,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.