[Federal Register Volume 59, Number 61 (Wednesday, March 30, 1994)]
[Unknown Section]
[Page 0]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 94-7492]
[[Page Unknown]]
[Federal Register: March 30, 1994]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
14 CFR Part 39
[Docket No. 94-NM-21-AD]
Airworthiness Directives; Fokker Model F28 Mark 0100 Series
Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: This document proposes the adoption of a new airworthiness
directive (AD) that is applicable to certain Fokker Model F28 Mark 0100
series airplanes. This proposal would require removal of the actuator
from the fuel-ballast transfer valve, and installation of a locking
device on the fuel-ballast transfer valve. This proposal is prompted by
a report that the fuel-ballast transfer valve on certain airplanes must
be modified to ensure the valve is closed at all times. If the transfer
valve is open during flight, the fuel supply to the engines may be
reduced during cross-feed operation to the extent that fuel starvation
could occur. The actions specified by the proposed AD are intended to
prevent engine flameout.
DATES: Comments must be received by May 23, 1994.
ADDRESSES: Submit comments in triplicate to the Federal Aviation
Administration (FAA), Transport Airplane Directorate, ANM-103,
Attention: Rules Docket No. 94-NM-21-AD, 1601 Lind Avenue, SW., Renton,
Washington 98055-4056. Comments may be inspected at this location
between 9 a.m. and 3 p.m., Monday through Friday, except Federal
holidays.
The service information referenced in the proposed rule may be
obtained from Fokker Aircraft USA, Inc., 1199 North Fairfax Street,
Alexandria, Virginia 22314. This information may be examined at the
FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington.
FOR FURTHER INFORMATION CONTACT: Tim Dulin, Aerospace Engineer,
Standardization Branch, ANM-113, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206)
227-2141; fax (206) 227-1320.
SUPPLEMENTARY INFORMATION:
Comments Invited -
Interested persons are invited to participate in the making of the
proposed rule by submitting such written data, views, or arguments as
they may desire. Communications shall identify the Rules Docket number
and be submitted in triplicate to the address specified above. All
communications received on or before the closing date for comments,
specified above, will be considered before taking action on the
proposed rule. The proposals contained in this notice may be changed in
light of the comments received. -
Comments are specifically invited on the overall regulatory,
economic, environmental, and energy aspects of the proposed rule. All
comments submitted will be available, both before and after the closing
date for comments, in the Rules Docket for examination by interested
persons. A report summarizing each FAA-public contact concerned with
the substance of this proposal will be filed in the Rules Docket. -
Commenters wishing the FAA to acknowledge receipt of their comments
submitted in response to this notice must submit a self-addressed,
stamped postcard on which the following statement is made: ``Comments
to Docket Number 94-NM-21-AD.'' The postcard will be date stamped and
returned to the commenter.
Availability of NPRMs -
Any person may obtain a copy of this NPRM by submitting a request
to the FAA, Transport Airplane Directorate, ANM-103, Attention: Rules
Docket No. 94-NM-21-AD, 1601 Lind Avenue, SW., Renton, Washington
98055-4056.
Discussion
The Rijksluchtvaartdienst (RLD), which is the airworthiness
authority for the Netherlands, recently notified the FAA that an unsafe
condition may exist on certain Fokker Model F28 Mark 0100 series
airplanes. The RLD advises that, with the introduction of integral
center wing fuel tanks, provisions for a fuel-ballast transfer system
were incorporated. This fuel-ballast transfer system allows the center
of gravity to be moved forward by transferring fuel from the main tanks
into the center wing tank for maintenance purposes. Installation of the
fuel-ballast transfer system is optional.
For airplanes that are not equipped with the optional fuel-ballast
transfer system, the transfer valve must be modified to ensure that the
valve is closed at all times. If the transfer valve is open during
flight, the fuel supply to the engines may be reduced during cross-feed
operation to the extent that fuel starvation could occur. This
condition, if not corrected, could result in engine flameout.
Fokker has issued Service Bulletin SBF100-28-029, Revision 1, dated
November 30, 1993, that describes procedures for removal of the
actuator from the fuel-ballast transfer valve, and installation of a
locking device on the fuel-ballast transfer valve. Accomplishment of
this installation will eliminate the possibility of a fuel-ballast
transfer valve inadvertently remaining open. The RLD classified this
service bulletin as mandatory and issued Netherlands Airworthiness
Directive BLA No. 93-160 (A), dated December 15, 1993, in order to
assure the continued airworthiness of these airplanes in the
Netherlands.
This airplane model is manufactured in the Netherlands and is type
certificated for operation in the United States under the provisions of
Sec. 21.29 of the Federal Aviation Regulations and the applicable
bilateral airworthiness agreement. Pursuant to this bilateral
airworthiness agreement, the RLD has kept the FAA informed of the
situation described above. The FAA has examined the findings of the
RLD, reviewed all available information, and determined that AD action
is necessary for products of this type design that are certificated for
operation in the United States.
Since an unsafe condition has been identified that is likely to
exist or develop on other airplanes of the same type design registered
in the United States, the proposed AD would require removal of the
actuator from the fuel-ballast transfer valve, and installation of a
locking device on the fuel-ballast transfer valve. The actions would be
required to be accomplished in accordance with the service bulletin
described previously.
The FAA estimates that 5 airplanes of U.S. registry would be
affected by this proposed AD, that it would take approximately 0.5 work
hour per airplane to accomplish the proposed actions, and that the
average labor rate is $55 per work hour. Required parts would cost
approximately $250 per airplane. Based on these figures, the total cost
impact of the proposed AD on U.S. operators is estimated to be
$1,387.50, or $277.50 per airplane.
The total cost impact figure discussed above is based on
assumptions that no operator has yet accomplished any of the proposed
requirements of this AD action, and that no operator would accomplish
those actions in the future if this AD were not adopted.
The regulations proposed herein would not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this
proposal would not have sufficient federalism implications to warrant
the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this proposed
regulation (1) is not a ``significant regulatory action'' under
Executive Order 12866; (2) is not a ``significant rule'' under the DOT
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
and (3) if promulgated, will not have a significant economic impact,
positive or negative, on a substantial number of small entities under
the criteria of the Regulatory Flexibility Act. A copy of the draft
regulatory evaluation prepared for this action is contained in the
Rules Docket. A copy of it may be obtained by contacting the Rules
Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration proposes to amend 14
CFR part 39 of the Federal Aviation Regulations as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C.
106(g); and 14 CFR 11.89.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
Fokker: Docket 94-NM-21-AD.
Applicability: Model F28 Mark 0100 series airplanes, serial
numbers 11443, 11446 through 11449 inclusive, and 11456;
certificated in any category.
Compliance: Required as indicated, unless accomplished
previously. -To prevent reduced fuel flow to the engines during
crossfeed operations and the possibility of engine flameout,
accomplish the following:
(a) Within 30 days after the effective date of this AD, remove
the actuator from the fuel-ballast transfer valve, part number
7933141J, and install a locking device on the fuel-ballast transfer
valve, in accordance with Fokker Service Bulletin SBF 100-28-029,
Revision 1, dated November 30, 1993.
(b) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, Standardization Branch, ANM-113,
FAA, Transport Airplane Directorate. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager,
Standardization Branch, ANM-113.
Note: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the Standardization Branch, ANM-113.
(c) Special flight permits may be issued in accordance with
Federal Aviation Regulations (FAR) 21.197 and 21.199 to operate the
airplane to a location where the requirements of this AD can be
accomplished.
Issued in Renton, Washington, on March 24, 1994.
John J. Hickey,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 94-7492 Filed 3-29-94; 8:45 am]
BILLING CODE 4910-13-U
