[Federal Register Volume 63, Number 98 (Thursday, May 21, 1998)]
[Proposed Rules]
[Pages 27870-27872]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-13518]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 98-CE-07-AD]
RIN 2120-AA64
Airworthiness Directives; Glaser-Dirks Flugzeugbau GmbH Model DG-
400 Gliders
AGENCY: Federal Aviation Administration, DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: This document proposes to adopt a new airworthiness directive
(AD) that would apply to all Glaser-Dirks Flugzeugbau GmbH (Glaser-
Dirks) Model DG-400 gliders. The proposed action would require
replacing the propeller shaft, the bearings, and the front drive belt
retaining rings with ones of improved design. The proposed AD is the
result of mandatory continuing airworthiness information (MCAI) issued
by the airworthiness authority for Germany. The actions specified by
the proposed AD are intended to prevent failure of the propeller shaft,
which could result in loss of glider propulsion during critical phases
of flight.
DATES: Comments must be received on or before June 26, 1998.
ADDRESSES: Submit comments in triplicate to the Federal Aviation
Administration (FAA), Central Region, Office of the Regional Counsel,
Attention: Rules Docket No. 98-CE-07-AD, Room 1558, 601 E. 12th Street,
Kansas City, Missouri 64106. Comments may be inspected at this location
between 8 a.m. and 4 p.m., Monday through Friday, holidays excepted.
Service information that applies to the proposed AD may be obtained
from Glaser-Dirks Flugzeugbau GmbH, Im Schollengarten 19-20, 7520
Bruchsal 4, Germany; telephone: +49 7257-89-0; facsimile: +49 7257-
8922. This information also may be examined at the Rules Docket at the
address above.
FOR FURTHER INFORMATION CONTACT: Mike Kiesov, Aerospace Engineer, FAA,
Small Airplane Directorate, Aircraft Certification Service, 1201
Walnut, suite 900, Kansas City, Missouri 64106; telephone: (816) 426-
6934; facsimile: (816) 426-2169.
SUPPLEMENTARY INFORMATION:
Comments Invited
Interested persons are invited to participate in the making of the
proposed rule by submitting such written data, views, or arguments as
they may desire. Communications should identify the Rules Docket number
and be submitted in triplicate to the address specified above. All
communications received on or before the closing date for comments,
specified above, will be considered before taking action on the
proposed rule. The proposals contained in this notice may be changed in
light of the comments received.
Comments are specifically invited on the overall regulatory,
economic, environmental, and energy aspects of the proposed rule. All
comments submitted will be available, both before and after the closing
date for comments, in the Rules Docket for examination by interested
persons. A report that summarizes each FAA-public contact concerned
with the substance of this proposal will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments
submitted in response to this notice must submit a self-addressed,
stamped postcard on which the following
[[Page 27871]]
statement is made: ``Comments to Docket No. 98-CE-07-AD.'' The postcard
will be date stamped and returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request
to the FAA, Central Region, Office of the Regional Counsel, Attention:
Rules Docket No. 98-CE-07-AD, Room 1558, 601 E. 12th Street, Kansas
City, Missouri 64106.
Discussion
The Luftfahrt-Bundesamt (LBA), which is the airworthiness authority
for Germany, recently notified the FAA that an unsafe condition may
exist on all Glaser-Dirks Model DG-400 gliders. The LBA reports that
the propeller shafts installed on some of these Model DG-400 gliders
have failed during flight. An LBA investigation of these incidents
showed that the propeller shaft currently installed had a torque
tensioning problem which was causing the shaft to rotate. In some
cases, the propeller drive belt damaged the front retaining rings and
came off the upper pulley, which also damaged the propeller.
These conditions, if not corrected, could result in loss of
propulsion during critical phases of flight.
Relevant Service Information
DG Flugzeugbau has issued Technical Note No. 826/32, dated July 19,
1996, and DG Flugzeugbau WORKING INSTRUCTION No. 1 for TN 826/32, dated
July, 1996, which specifies procedures for replacing the propeller
shaft, the bearings, and the front drive belt retaining rings with
parts of improved design.
The LBA classified this service bulletin as mandatory and issued
German AD 96-243 DG Flugzeugbau, dated August 29, 1996, in order to
assure the continued airworthiness of these gliders in Germany.
The FAA's Determination
This glider model is manufactured in Germany and is type
certificated for operation in the United States under the provisions of
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and
the applicable bilateral airworthiness agreement. Pursuant to this
bilateral airworthiness agreement, the LBA has kept the FAA informed of
the situation described above.
The FAA has examined the findings of the LBA; reviewed all
available information, including the service information referenced
above; and determined that AD action is necessary for products of this
type design that are certificated for operation in the United States.
Explanation of the Provisions of the Proposed AD
Since an unsafe condition has been identified that is likely to
exist or develop in other Glaser-Dirks Model DG-400 gliders of the same
type design registered in the United States, the FAA is proposing AD
action. The proposed AD would require replacing the propeller shaft,
the bearings, and the front drive belt retaining rings with parts of
improved design. Accomplishment of the proposed action would be in
accordance with DG Flugzeugbau Technical Note No. 826/32, dated July
19, 1996, and DG Flugzeugbau WORKING INSTRUCTION No. 1 for TN 826/32,
dated July, 1996.
Cost Impact
The FAA estimates that 35 gliders in the U.S. registry would be
affected by the proposed AD, that it would take approximately 5
workhours per glider to accomplish the proposed action, and that the
average labor rate is approximately $60 an hour. Parts cost
approximately $460 per glider. Based on these figures, the total cost
impact of the proposed AD on U.S. operators is estimated to be
$266,000, or $760 per glider.
Proposed Compliance Time
The compliance time of the proposed AD is in calendar time instead
of hours time-in-service (TIS). The average monthly usage of the
affected glider ranges throughout the fleet. For example, one owner may
operate the glider 25 hours TIS in one week, while another operator may
operate the glider 25 hours TIS in one year. In order to ensure that
all of the owners/operators of the affected glider have replaced the
propeller shaft, bearings and front drive belt retaining rings within a
reasonable amount of time, the FAA is proposing a compliance time of 4
calendar months.
Regulatory Impact
The regulations proposed herein would not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this
proposal would not have sufficient federalism implications to warrant
the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated,
will not have a significant economic impact, positive or negative, on a
substantial number of small entities under the criteria of the
Regulatory Flexibility Act. A copy of the draft regulatory evaluation
prepared for this action has been placed in the Rules Docket. A copy of
it may be obtained by contacting the Rules Docket at the location
provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration proposes to amend
part 39 of the Federal Aviation Regulations (14 CFR part 39) as
follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding a new airworthiness directive
(AD) to read as follows:
Glaser-Dirks Flugzeugbau GMBH: Docket No. 98-CE-07-AD.
Applicability: Model DG-400 gliders, all serial numbers,
certificated in any category.
Note 1: This AD applies to each glider identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For gliders that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (c) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required within the next 4 calendar months after the
effective date of this AD, unless already accomplished.
To prevent failure of the propeller shaft, which could result in
loss of glider propulsion during critical phases of flight,
accomplish the following:
(a) Replace the propeller shaft, the bearings, and the front
drive belt retaining rings with parts of improved design in
[[Page 27872]]
accordance with paragraph 2 of the Instructions section of DG
Flugzeugbau Technical Note No. 826/32, dated July 19, 1996, and
WORKING INSTRUCTION No. 1 for TN 826/32, dated July, 1996.
(b) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the glider to a location where the
requirements of this AD can be accomplished.
(c) An alternative method of compliance or adjustment of the
compliance time that provides an equivalent level of safety may be
approved by the Manager, Small Airplane Directorate, FAA, 1201
Walnut, suite 900, Kansas City, Missouri 64106. The request shall be
forwarded through an appropriate FAA Maintenance Inspector, who may
add comments and then send it to the Manager, Small Airplane
Directorate.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the Small Airplane Directorate.
(d) Questions or technical information related to DG Flugzeugbau
Technical Note No. 826/32, dated July 19, 1996, and DG Flugzeugbau
WORKING INSTRUCTION No. 1 for TN 826/32, dated July, 1996, should be
directed to DG Flugzeugbau GmbH, P.O. Box 4120, 76625 Bruchsal,
Germany; telephone: +49 7257-89-0; facsimile: +49 7257-8922. This
service information may be examined at the FAA, Central Region,
Office of the Regional Counsel, Room 1558, 601 E. 12th Street,
Kansas City, Missouri 64106.
Note 3: The subject of this AD is addressed in German AD 96-243
DG-Flugzeugbau, dated August 29, 1996.
Issued in Kansas City, Missouri, on May 13, 1998.
Michael Gallagher,
Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. 98-13518 Filed 5-20-98; 8:45 am]
BILLING CODE 4910-13-U
