01-15936. Airworthiness Directives; Airbus Model A300 B2-1C, B2-203, B2K-3C, B4-2C, B4-103, and B4-203 Series Airplanes

AGENCY:

Federal Aviation Administration, DOT.

ACTION:

Final rule.

SUMMARY:

This amendment adopts a new airworthiness directive (AD), applicable to all Airbus Model A300 B2-1C, B2-203, B2K-3C, B4-2C, B4-103, and B4-203 series airplanes, that requires a one-time inspection of the space between the fuel quantity indication (FQI) probes and any adjacent structures for minimum clearance, and corrective action, if necessary. The actions specified by this AD are intended to prevent the possibility of electrical arcing to the fuel tank if the airplane should be struck by lightning. This action is intended to address the identified unsafe condition.

DATES:

Effective August 1, 2001.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of August 1, 2001.

ADDRESSES:

The service information referenced in this AD may be obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT:

Dan Rodina, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone [phone]; fax [phone].

SUPPLEMENTARY INFORMATION:

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to all Airbus Model A300 B2-1C, B2-203, B2K-3C, B4-2C, B4-103, and B4-203 series airplanes was published in the Federal Register on May 4, 2001 (66 FR 22478). That action proposed to require a one-time inspection of the space between the fuel quantity indication (FQI) probes and any adjacent structures for minimum clearance, and corrective action, if necessary.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact

The FAA estimates that 20 airplanes of U.S. registry will be affected by this AD, that it will take approximately 7 work hours per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $8,400, or $420 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

2001-13-09 Airbus Industrie: Amendment 39-12289. Docket 2000-NM-374-AD.

Applicability: All Model A300 B2-1C, B2-203, B2K-3C, B4-2C, B4-103, and B4-203 series airplanes, certificated in any category.

Note 1:

This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent the possibility of electrical arcing to the fuel tank if the airplane should be struck by lightning, accomplish the following:

Inspection

(a) Within 4,000 flight hours after the effective date of this AD, inspect the clearance space from each fuel quantity indication (FQI) probe to any adjacent structure or metallic component, in accordance with Airbus Service Bulletin A300-28-0080, dated September 28, 2000.

Clearance Adjustment

(b) If, during the inspection mandated in paragraph (a) of this AD, the clearance between any probe and its adjacent parts, as described in Airbus Service Bulletin A300-28-0080, dated September 28, 2000, is less than 3.0 mm (0.118 in.), prior to further flight, adjust the position of the FQI probe in accordance with paragraph 3.C. of the service bulletin.

Alternative Methods of Compliance

(c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

Note 2:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.

Special Flight Permits

(d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Incorporation by Reference

(e) The actions shall be done in accordance with Airbus Service Bulletin A300-28-0080, dated September 28, 2000. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Note 3:

The subject of this AD is addressed in French airworthiness directive 2000-455-322(B), dated November 15, 2000.

Effective Date

(f) This amendment becomes effective on August 1, 2001.

Issued in Renton, Washington, on June 19, 2001.

Kalene C. Yanamura,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.