2015-17193. Airworthiness Directives; GA 8 Airvan (Pty) Ltd Airplanes

AGENCY:

Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION:

Final rule.

SUMMARY:

We are revising an airworthiness directive (AD) 2015-06-02 for GA 8 Airvan (Pty) Ltd Model GA8-TC320 airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as missing required engine mount fire seal washers, which could reduce the engine retention capability in the event of a fire. We are issuing this AD to require actions to address the unsafe condition on these products.

DATES:

This AD is effective August 20, 2015.

The Director of the Federal Register approved the incorporation by reference of a certain other publication listed in this AD as of April 24, 2015 (80 FR 14810, March 20, 2015).

ADDRESSES:

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-1123; or in person at the Docket Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.

For service information identified in this AD, contact GA 8 Airvan (Pty) Ltd, c/o GippsAero Pty Ltd, Attn: Technical Services, P.O. Box 881, Morwell Victoria 3840, Australia; telephone: + 61 03 5172 1200; fax: [phone]; email: [e-mail]; Internet: http://www.gippsaero.com/​customer-support/​technical-publications.aspx. You may view this referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call [phone]. It is also available on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-1123.

FOR FURTHER INFORMATION CONTACT:

Doug Rudolph, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: [phone]; fax: [phone]; email: [e-mail].

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to add an AD that would apply to GA 8 Airvan (Pty) Ltd Model GA8-TC320 airplanes. The NPRM was published in the Federal Register on April 17, 2015 (74 FR 21193), and proposed to revise AD 2015-06-02, Amendment 39-18120 (80 FR 14810; March 20, 2015).

The NPRM proposed to correct an unsafe condition for the specified products and was based on mandatory continuing airworthiness information originated by an airworthiness authority of another country. The MCAI states that:

A recent review of the engine mount installation on the GA8-TC 320 aircraft has highlighted the omission of engine mount fire seal washers during the assembly process.

The current engine mount configuration does not meet the certification basis for the aircraft, specifically regulation 23.865 of the Federal Aviation Regulations of the United States of America, where engine mounts located in designated fire zones are required to be suitably shielded so that they are capable of withstanding the effects of a fire.

The Gippsland Aeronautics GA8-TC 320 aircraft require the installation of an approved steel washer at each of the engine mount locations to address a potential risk of reduced engine retention capability in the event of a fire.

This AD, AD/GA8/8 Amdt 1, amends the applicability statement to be inclusive of the affected aircraft serial number range.

The MCAI can be found in the AD docket on the Internet at: http://www.regulations.gov/​#!documentDetail;​D=​FAA-2014-1123-0007.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (74 FR 21193, April 17, 2015) or on the determination of the cost to the public.

Conclusion

We reviewed the relevant data and determined that air safety and the public interest require adopting the AD as proposed except for minor editorial changes. We have determined that these minor changes:

• Are consistent with the intent that was proposed in the NPRM (74 FR 21193, April 17, 2015) for correcting the unsafe condition; and
• Do not add any additional burden upon the public than was already proposed in the NPRM (74 FR 21193, April 17, 2015).

Relative Service Information Under 1 CFR Part 51

We reviewed GippsAero Mandatory Service Bulletin SB-GA8-2014-115, Issue 1, dated October 6, 2014. The service bulletin describes procedures for inspecting the orientation of the engine isolator mounts to verify proper installation, re-installing if necessary, and installing steel washers on the forward side of each side of the engine isolator mounts. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section of this AD.

Costs of Compliance

We estimate that this AD will affect 13 products of U.S. registry. We also estimate that it would take about 5 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts would cost about $10 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-1123; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone [phone]) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. The FAA amends § 39.13 by removing Amendment 39-18120 ( 80 FR 14810, March 20, 2015), and adding the following new AD:

2015-06-02 R1 GA 8 Airvan (Pty) Ltd: Amendment 39-18209; Docket No. FAA-2014-1123; Directorate Identifier 2014-CE-037-AD.

(a) Effective Date

This airworthiness directive (AD) becomes effective August 20, 2015.

(b) Affected ADs

This AD revises AD 2015-06-02, Amendment 39-18120 (80 FR 14810; March 20, 2015).

(c) Applicability

This AD applies to GA 8 Airvan (Pty) Ltd GA8-TC320 airplanes, all serial numbers up to and including GA8-TC 320-14-205, certificated in any category.

(d) Subject

Air Transport Association of America (ATA) Code 71: Power Plant.

(e) Reason

This AD was prompted by mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as missing required engine mount fire seal washers, which could reduce the engine retention capability in the event of a fire. We are issuing this AD to revise the applicable airplane serial numbers and to detect and correct the omission of steel washers at each isolator mount location, which, if not corrected, could result in reduced engine retention capability in the event of a fire.

(f) Actions and Compliance

Unless already done, comply with this AD within the compliance times specified in paragraphs (f)(1) through (f)(3) of this AD:

(1) Within the next 300 hours time-in-service after April 24, 2015 (the effective date retained from AD 2015-22-14) or within the next 12 months after April 24, 2015 (the effective date retained from AD 2015-22-14), whichever occurs first, inspect the orientation of the engine isolator mounts to verify that the mounts have been installed properly following the Accomplishment Instructions in GippsAero Mandatory Service Bulletin SB-GA8-2014-115, Issue 1, dated October 6, 2014.

(2) Before reinstalling the engine isolator mounts following the inspection required in paragraph (f)(1) of this AD, before further flight, install a part number J-2218-61 steel washer on the forward side of each of the four engine isolator mounts, following the Accomplishment Instructions in GippsAero Mandatory Service Bulletin SB-GA8-2014-115, Issue 1, dated October 6, 2014.

(3) If during the inspection required in paragraph (f)(1) of this AD, any of the engine isolator mounts are found to not comply with the specifications found in the Accomplishment Instructions of GippsAero Mandatory Service Bulletin SB-GA8-2014-115, Issue 1, dated October 6, 2014, before further flight, re-install the isolators to the correct orientation, or if damage is found, replace with airworthy parts.

(g) Other FAA AD Provisions

The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Doug Rudolph, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: [phone]; fax: [phone]; email: [e-mail]. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(h) Related Information

Refer to MCAI Civil Aviation Safety Authority (CASA) AD No. AD/GA8/8, Amdt 1, dated March 26, 2015. The MCAI can be found in the AD docket on the Internet at: http://www.regulations.gov/​#!documentDetail;​D=​FAA-2014-1123-0007.

(i) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.

(3) The following service information was approved for IBR on April 24, 2015 (80 FR 14810, March 20, 2015).

(i) GippsAero Mandatory Service Bulletin SB-GA8-2014-115, Issue 1, dated October 6, 2014.

(ii) Reserved.

(4) For GippsAero service information identified in this AD, contact GA 8 Airvan (Pty) Ltd, c/o GippsAero Pty Ltd, Attn: Technical Services, P.O. Box 881, Morwell Victoria 3840, Australia; telephone: + 61 03 5172 1200; fax: [phone]; email: [e-mail]; Internet: http://www.gippsaero.com/​customer-support/​technical-publications.aspx.

(5) You may view this service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call [phone]. In addition, you can access this service information on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-1123.

(6) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/​federal-register/​cfr/​ibr-locations.html.

Issued in Kansas City, Missouri, on July 7, 2015.

Earl Lawrence,

Manager, Small Airplane Directorate, Aircraft Certification Service.