2017-17590. Airworthiness Directives; Bombardier, Inc., Airplanes

AGENCY:

Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION:

Final rule.

SUMMARY:

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-600-2E25 (Regional Jet Series 1000) airplanes. This AD was prompted by reports of failures of the landing gear alternate-extension system. This AD requires replacement of certain nose landing gear and main landing gear electro-mechanical actuators. We are issuing this AD to address the unsafe condition on these products.

DATES:

This AD is effective October 2, 2017.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of October 2, 2017.

ADDRESSES:

For service information identified in this final rule, contact Bombardier, Inc., 400 Côte-Vertu Road West, Dorval, Québec H4S 1Y9, Canada; Widebody Customer Response Center North America toll-free telephone [phone] or direct-dial telephone: [phone]; fax: [phone]; email: [e-mail]; Internet: http://www.bombardier.com. You may view this referenced service information at the FAA, Transport Standards Branch, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. It is also available on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0512.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0512; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone [phone]) is Docket Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT:

Cesar Gomez, Aerospace Engineer, Airframe and Mechanical Systems Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone: [phone]; fax: [phone].

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Bombardier, Inc., Model CL-600-2E25 (Regional Jet Series 1000) airplanes. The NPRM published in the Federal Register on June 2, 2017 (82 FR 25545) (“the NPRM”). The NPRM was prompted by reports of failures of the landing gear alternate-extension system (AES). The NPRM proposed to require replacement of certain nose landing gear and main landing gear electro-mechanical actuators. We are issuing this AD to prevent failure of the landing gear AES and consequent landing with some or all of the landing gear not extended.

Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian AD CF-2017-08, dated February 22, 2017 (referred to after this as the Mandatory Continuing Airworthiness Information, or “the MCAI”), to correct an unsafe condition for certain Bombardier, Inc., Model CL-600-2E25 (Regional Jet Series 1000) airplanes. The MCAI states:

Malfunctions of the landing gear Alternate-Extension System (AES) have been experienced. Failure of the landing gear AES could prevent the landing gear from extending in the case of a failure of the primary landing gear extension system.

This [Canadian] AD is issued to mandate the replacement of the [nose landing gear] NLG and [main landing gear] MLG [electro-mechanical actuators] EMA [part numbers] P/Ns BA698-85006-1 and BA698-85007-1.

You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0512.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Conclusion

We reviewed the relevant data and determined that air safety and the public interest require adopting this AD as proposed except for minor editorial changes. We have determined that these minor changes:

• Are consistent with the intent that was proposed in the NPRM for correcting the unsafe condition; and
• Do not add any additional burden upon the public than was already proposed in the NPRM.

Related Service Information Under 1 CFR Part 51

Bombardier, Inc., has issued Service Bulletin 670BA-32-047, Revision A, dated December 5, 2016. The service information describes procedures for replacing certain nose landing gear and main landing gear electro-mechanical actuators. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

Costs of Compliance

We estimate that this AD will affect 39 airplanes of U.S. registry. We estimate the following costs to comply with this AD:

Estimated Costs

Action	Labor cost	Parts cost	Cost per product	Cost on U.S. operators
Replacement	4 work-hours × $85 per hour = $340	Not available	$340	$13,260

According to the manufacturer, some of the costs of this AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we have included all available costs in our cost estimate.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

This AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to transport category airplanes to the Director of the System Oversight Division.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);

3. Will not affect intrastate aviation in Alaska; and

4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

2017-17-15 Bombardier, Inc.: Amendment 39-19005; Docket No. FAA-2017-0512; Product Identifier 2017-NM-031-AD.

(a) Effective Date

This AD is effective October 2, 2017.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Bombardier, Inc., Model CL-600-2E25 (Regional Jet Series 1000) airplanes, certificated in any category, serial numbers 19001 through 19039 inclusive.

(d) Subject

Air Transport Association (ATA) of America Code 32, Landing gear.

(e) Reason

This AD was prompted by failures of the landing gear alternate-extension system (AES). We are issuing this AD to prevent failure of the landing gear AES and consequent landing with some or all of the landing gear not extended.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Replacement

Within 1,200 flight hours or 12 months after the effective date of this AD, whichever occurs first: Replace the nose landing gear (NLG) and main landing gear (MLG) electro-mechanical actuators (EMAs) having part numbers (P/Ns) BA698-85006-1 and BA698-85007-1 with P/Ns BA698-85006-3 and BA698-85007-3, as applicable, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 670BA-32-047, Revision A, dated December 5, 2016 (“670BA-32-047, Revision A”). Where 670BA-32-047, Revision A, instructs operators to contact Bombardier if it is not possible to complete all the instructions in 670BA-32-047, Revision A, because of the configuration of the airplane, this AD requires that any deviation from the instructions provided in 670BA-32-047, Revision A, must be approved as an alternative method of compliance (AMOC) under the provisions of paragraph (j)(1) of this AD.

(h) Parts Installation Prohibition

As of the effective date of this AD, no person may install an NLG or MLG EMA having P/N BA698-85006-1 or BA698-85007-1, on any airplane.

(i) Credit for Previous Actions

This paragraph provides credit for actions required by paragraph (g) of this AD, if those actions were performed before the effective date of this AD using Bombardier Service Bulletin 670BA-32-047, dated February 28, 2014.

(j) Other FAA AD Provisions

The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, New York ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone: [phone]; fax: [phone]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, New York ACO Branch, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier, Inc.'s TCCA Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.

(k) Related Information

(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian Airworthiness Directive CF-2017-08, dated February 22, 2017, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0512.

(2) For more information about this AD, contact Cesar Gomez, Aerospace Engineer, Airframe and Mechanical Systems Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone: [phone]; fax: [phone].

(3) Service information identified in this AD that is not incorporated by reference is available at the addresses specified in paragraphs (l)(3) and (l)(4) of this AD.

(l) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.

(i) Bombardier Service Bulletin 670BA-32-047, Revision A, dated December 5, 2016.

(ii) Reserved.

(3) For service information identified in this AD, contact Bombardier, Inc., 400 Côte-Vertu Road West, Dorval, Québec H4S 1Y9, Canada; Widebody Customer Response Center North America toll-free telephone [phone] or direct-dial telephone: [phone]; fax: [phone]; email: [e-mail]; Internet: http://www.bombardier.com.

(4) You may view this service information at the FAA, Transport Standards Branch, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/​federal-register/​cfr/​ibr-locations.html.

Issued in Renton, Washington, on August 10, 2017.

Dionne Palermo,

Acting Director, System Oversight Division, Aircraft Certification Service.