2018-19174. Airworthiness Directives; International Aero Engines Turbofan Engines  

  • Start Preamble

    AGENCY:

    Federal Aviation Administration (FAA), DOT.

    ACTION:

    Notice of proposed rulemaking (NPRM).

    SUMMARY:

    We propose to adopt a new airworthiness directive (AD) for all International Aero Engines (IAE) PW1133G-JM, PW1133GA-JM, PW1130G-JM, PW1127G-JM, PW1127GA-JM, PW1127G1-JM, PW1124G-JM, PW1124G1-JM, and PW1122G-JM turbofan engines with certain low-pressure turbine (LPT) 1st- and 3rd-stage disks installed. This proposed AD was prompted by a report of manufacturing defects found on delivered LPT 1st- and 3rd-stage disks. This proposed AD would require removing the LPT 1st- or 3rd-stage disk from service and replacing with a part eligible for installation. We are proposing this AD to address the unsafe condition on these products.

    DATES:

    We must receive comments on this proposed AD by October 22, 2018.

    ADDRESSES:

    You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

    • Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
    • Fax: 202-493-2251.
    • Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC, 20590.
    • Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

    Examining the AD Docket

    You may examine the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-0735; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, the regulatory evaluation, any comments received, and other information. The street address for Docket Operations (phone: 800-647-5527) is listed above. Comments will be available in the AD docket shortly after receipt.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Kevin M. Clark, Aerospace Engineer, ECO Branch, FAA, 1200 District Avenue, Burlington MA, 01803; phone: 781-238-7088; fax: 781-238-7199; email: kevin.m.clark@faa.gov.

    End Further Info End Preamble Start Supplemental Information Start Printed Page 45360

    SUPPLEMENTARY INFORMATION:

    Comments Invited

    We invite you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2018-0735; Product Identifier 2018-NE-26-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this NPRM. We will consider all comments received by the closing date and may amend this NPRM because of those comments.

    We will post all comments we receive, without change, to http://www.regulations.gov,, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this NPRM.

    Discussion

    We received a report that multiple LPT 1st- and 3rd-stage disks were delivered before the ingot lot was rejected due to material inclusion. The suspect LPT 1st- and 3rd-stage disks may include defects that may have not been discovered during inspections. This condition, if not addressed, could result in uncontained LPT 1st- or 3rd-stage disk release, damage to the engine, and damage to the airplane.

    FAA's Determination

    We are proposing this AD because we evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.

    Proposed AD Requirements

    This proposed AD would require removing from service and replacing the LPT 1st- or 3rd-stage disk with a part eligible for installation.

    Costs of Compliance

    We estimate that this proposed AD affects 0 engines installed on airplanes of U.S. registry.

    We estimate the following costs to comply with this proposed AD:

    Estimated Costs

    ActionLabor costParts costCost per productCost on U.S. operators
    Remove and replace LPT 1st- or 3rd-stage disk0 work-hours × $85 per hour = $0$210,000$210,000$0

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

    We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    This AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to engines, propellers, and associated appliances to the Manager, Engine and Propeller Standards Branch, Policy and Innovation Division.

    Regulatory Findings

    We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify this proposed regulation:

    (1) Is not a “significant regulatory action” under Executive Order 12866,

    (2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

    (3) Will not affect intrastate aviation in Alaska, and

    (4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    The Proposed Amendment

    Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

    Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

    End Amendment Part

    International Aero Engines: Docket No. FAA-2018-0735; Product Identifier 2018-NE-26-AD.

    (a) Comments Due Date

    We must receive comments by October 22, 2018.

    (b) Affected ADs

    None.

    (c) Applicability

    This AD applies to International Aero Engines (IAE) PW1133G-JM, PW1133GA-JM, PW1130G-JM, PW1127G-JM, PW1127GA-JM, PW1127G1-JM, PW1124G-JM, PW1124G1-JM, and PW1122G-JM turbofan engines with a low-pressure turbine (LPT) 3rd-stage disk with a serial number (S/N) listed in Figure 1 to paragraph (g) of this AD or an LPT 1st-stage disk with an S/N listed in Figure 2 to paragraph (g) of this AD, installed.

    (d) Subject

    Joint Aircraft System Component (JASC) Code 7250, Turbine Section.

    (e) Unsafe Condition

    This AD was prompted by a report of manufacturing defects found on delivered Start Printed Page 45361LPT 1st- and 3rd-stage disks. We are issuing this AD to prevent failure of the LPT 1st- or 3rd-stage disk. The unsafe condition, if not addressed, could result in uncontained LPT 1st- or 3rd-stage disk release, damage to the engine, and damage to the airplane.

    (f) Compliance

    Comply with this AD within the compliance times specified, unless already done.

    (g) Required Actions

    Remove from service the LPT 1st- or 3rd-stage disk within 30 days after the effective date of this AD, or as identified in paragraphs (g)(1) or (2) of this AD, whichever occurs later, and replace with a part eligible for installation:

    (1) Remove the LPT 3rd-stage disk with an S/N listed in Figure 1 to paragraph (g) of this AD at the next shop visit, not to exceed 4,800 cycles since new.

    (2) Remove the LPT 1st-stage disk with an S/N listed in Figure 2 to paragraph (g) of this AD at next shop visit, not to exceed 2,240 cycles since new.

    (h) Definitions

    For the purpose of this AD, an “engine shop visit” is the induction of an engine into the shop for maintenance involving the separation of pairs of major mating engine flanges, except that the separation of engine flanges solely for the purposes of transportation of the engine without subsequent engine maintenance does not constitute an engine shop visit.

    (i) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, ECO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, Start Printed Page 45362send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to the attention of the person identified in paragraph (j) of this AD. You may email your request to: ANE-AD-AMOC@faa.gov.

    (2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

    (j) Related Information

    For more information about this AD, contact Kevin M. Clark, Aerospace Engineer, ECO Branch, FAA, 1200 District Avenue, Burlington, MA 01803; phone: 781-238-7088; fax: 781-238-7199; email: kevin.m.clark@faa.gov.

    Start Signature

    Issued in Burlington, Massachusetts, on August 29, 2018.

    Karen M. Grant,

    Acting Manager, Engine and Propeller Standards Branch, Aircraft Certification Service.

    End Signature End Supplemental Information

    [FR Doc. 2018-19174 Filed 9-6-18; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Published:
09/07/2018
Department:
Federal Aviation Administration
Entry Type:
Proposed Rule
Action:
Notice of proposed rulemaking (NPRM).
Document Number:
2018-19174
Dates:
We must receive comments on this proposed AD by October 22, 2018.
Pages:
45359-45362 (4 pages)
Docket Numbers:
Docket No. FAA-2018-0735, Product Identifier 2018-NE-26-AD
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
2018-19174.Pdf
Supporting Documents:
» U.S. DOT/FAA - Regulatory Evaluation Form
CFR: (1)
14 CFR 39.13