2022-10528. Airworthiness Directives; MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.) Airplanes

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

The FAA proposes to adopt a new airworthiness directive (AD) for certain MHI RJ Aviation ULC Model CL-600-2C10 (Regional Jet Series 700, 701 & 702); CL-600-2C11 (Regional Jet Series 550); CL-600-2D15 (Regional Jet Series 705); CL-600-2D24 (Regional Jet Series 900); and CL-600-2E25 (Regional Jet Series 1000) airplanes. This proposed AD was prompted by laboratory tests that showed that the oxygen tubes of the crew oxygen system may be contaminated with lubricants, as a result of the manufacturing and cleaning procedures used. This proposed AD would require cleaning and flushing the crew oxygen system. The FAA is proposing this AD to address the unsafe condition on these products.

DATES:

The FAA must receive comments on this proposed AD by July 1, 2022.

ADDRESSES:

You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

• Federal eRulemaking Portal: Go to https://www.regulations.gov . Follow the instructions for submitting comments.

• Fax: [phone].

• Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.

• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

For service information identified in this NPRM, contact MHI RJ Aviation ULC, 12655 Henri-Fabre Blvd., Mirabel, Québec J7N 1E1 Canada; Widebody Customer Response Center North America toll-free telephone [phone] or direct-dial telephone [phone]; fax [phone]; email [e-mail]; internet https://mhirj.com . You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195.

Examining the AD Docket

You may examine the AD docket at https://www.regulations.gov by searching for and locating Docket No. FAA-2022-0521; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, any comments received, and other information. The street address for Docket Operations is listed above.

FOR FURTHER INFORMATION CONTACT:

Chirayu Gupta, Aerospace Engineer, Mechanical Systems and Administrative Services Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone [phone]; email [e-mail] .

SUPPLEMENTARY INFORMATION:

Comments Invited

The FAA invites you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under ADDRESSES . Include “Docket No. FAA-2022-0521; Project Identifier MCAI-2022-00273-T” at the beginning of your comments. The most helpful comments reference a specific portion of the proposal, explain the reason for any recommended change, and include supporting data. The FAA will consider all comments received by the closing date and may amend the proposal because of those comments.

Except for Confidential Business Information (CBI) as described in the following paragraph, and other information as described in 14 CFR 11.35, the FAA will post all comments received, without change, to https://www.regulations.gov, including any personal information you provide. The agency will also post a report summarizing each substantive verbal contact received about this NPRM.

Confidential Business Information

CBI is commercial or financial information that is both customarily and actually treated as private by its owner. Under the Freedom of Information Act (FOIA) (5 U.S.C. 552), CBI is exempt from public disclosure. If your comments responsive to this NPRM contain commercial or financial information that is customarily treated as private, that you actually treat as private, and that is relevant or responsive to this NPRM, it is important that you clearly designate the submitted comments as CBI. Please mark each page of your submission containing CBI as “PROPIN.” The FAA will treat such marked submissions as confidential under the FOIA, and they will not be placed in the public docket of this NPRM. Submissions containing CBI should be sent to Chirayu Gupta, Aerospace Engineer, Mechanical Systems and Administrative Services Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone [phone]; email [e-mail] . Any commentary that the FAA receives which is not specifically designated as CBI will be placed in the public docket for this rulemaking.

Background

Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued TCCA AD CF-2022-06, dated February 28, 2022 (TCCA AD CF-2022-06) (also referred to after this as the Mandatory Continuing Airworthiness Information, or the MCAI), to correct an unsafe condition for certain MHI RJ Aviation ULC Model CL-600-2C10 (Regional Jet Series 700, 701 & 702); CL-600-2C11 (Regional Jet Series 550); CL-600-2D15 (Regional Jet Series 705); CL-600-2D24 (Regional Jet Series 900); and CL-600-2E25 (Regional Jet Series 1000) airplanes. You may examine the MCAI in the AD docket at https://www.regulations.gov by searching for and locating Docket No. FAA-2022-0521.

This proposed AD was prompted by laboratory tests that showed that the oxygen tubes of the crew oxygen system may be contaminated with lubricants, as a result of the inadvertent use of a non-conforming aqueous degreasing process for oxygen line flushing and cleaning during the manufacturing process. The FAA is proposing this AD to address the contaminated oxygen tubes of the crew oxygen system, which could lead to a fire within the oxygen tubes, or a health hazard related to the inhalation of lubricant fumes when the masks are in use. See the MCAI for additional background information.

Related Service Information Under 1 CFR Part 51

MHI RJ has issued Service Bulletin 670BA-35-016, Revision B, dated December 17, 2021. This service information describes procedures for low-pressure and high-pressure cleaning of the crew oxygen tubes. The tasks include cleaning the end fittings and threads, cleaning the inner wall of the tubes with solvent, and flushing the inner wall of the tubes with nitrogen. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

FAA's Determination

This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to the FAA's bilateral agreement with the State of Design Authority, the FAA has been notified of the unsafe condition described in the MCAI and service information referenced above. The FAA is proposing this AD because the FAA evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop on other products of the same type design.

Proposed AD Requirements in This NPRM

This proposed AD would require accomplishing the actions specified in the service information already described.

Costs of Compliance

The FAA estimates that this AD, if adopted as proposed, would affect 34 airplanes of U.S. registry. The FAA estimates the following costs to comply with this proposed AD:

Estimated Costs for Required Actions

Labor cost	Parts cost	Cost per product	Cost on U.S. operators
51 work-hours × $85 per hour = $4,335	Up to $1,240	Up to $5,575	Up to $189,550.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

The FAA determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed regulation:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Would not affect intrastate aviation in Alaska, and

(3) Would not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. The FAA amends § 39.13 by adding the following new airworthiness directive:

MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.): Docket No. FAA-2022-0521; Project Identifier MCAI-2022-00273-T.

(a) Comments Due Date

The FAA must receive comments on this airworthiness directive (AD) by July 1, 2022.

(b) Affected ADs

None.

(c) Applicability

This AD applies to MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.) airplanes identified in paragraphs (c)(1) through (4) of this AD certificated in any category.

(1) Model CL-600-2C10 (Regional Jet Series 700, 701 & 702) and CL-600-2C11 (Regional Jet Series 550) airplanes, serial numbers 10346 and 10347.

(2) Model CL-600-2D15 (Regional Jet Series 705) and CL-600-2D24 (Regional Jet Series 900) airplanes, serial numbers 15413 through 15484 inclusive.

(3) Model CL-600-2E25 (Regional Jet Series 1000) airplanes, serial numbers 19049 through 19064 inclusive.

(4) Model CL-600-2C10, CL-600-2C11, CL-600-2D15, CL-600-2D24 and CL-600-2E25 airplanes equipped with tube part numbers installed after the dates indicated in Section 1.A.(2) of MHIRJ Service Bulletin (SB) 670BA-35-016, Revision B, dated December 17, 2021.

(d) Subject

Air Transport Association (ATA) of America Code 35, Oxygen.

(e) Unsafe Condition

This proposed AD was prompted by laboratory tests that showed that the oxygen tubes of the crew oxygen system may be contaminated with lubricants, as a result of the manufacturing and cleaning procedures. The FAA is proposing this AD to address the contaminated oxygen tubes of the crew oxygen system, which could lead to a fire within the oxygen tubes, or a health hazard related to the inhalation of lubricant fumes when the masks are in use.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Requirements

Within 8,800 flight hours after the effective date of this AD, clean and flush the crew oxygen system, in accordance with the Accomplishment Instructions of MHIRJ Service Bulletin 670BA-35-016, Revision B, dated December 17, 2021.

(h) Credit for Previous Actions

This paragraph provides credit for actions required by this AD, if those actions were performed before the effective date of this AD, using the service information identified in paragraph (h)(1) or (2) of this AD.

(1) MHI RJ Service Bulletin 670BA-35-016, dated February 26, 2021.

(2) MHI RJ Service Bulletin 670BA-35-016, Revision A, dated November 5, 2021.

(i) Other FAA AD Provisions

The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, New York ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the certification office, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone [phone]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.

(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, New York ACO Branch, FAA; or Transport Canada Civil Aviation (TCCA); or MHI RJ Aviation ULC's TCCA Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.

(j) Related Information

(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) TCCA CF-2022-06, dated February 28, 2022, for related information. This MCAI may be found in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2022-0521.

(2) For more information about this AD, contact Chirayu Gupta, Aerospace Engineer, Mechanical Systems and Administrative Services Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone [phone]; email [e-mail] .

(3) For service information identified in this AD, contact MHI RJ Aviation ULC, 12655 Henri-Fabre Blvd., Mirabel, Québec J7N 1E1 Canada; Widebody Customer Response Center North America toll-free telephone [phone] or direct-dial telephone [phone]; fax [phone]; email [e-mail]; internet https://mhirj.com . You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195.

Issued on May 9, 2022.

Gaetano A. Sciortino,

Deputy Director for Strategic Initiatives, Compliance & Airworthiness Division, Aircraft Certification Service.